Trojan Velocity 410 Owner's manual

Trojan
Brand
Trojan
Model
Velocity 410
Type
Owner's manual
www.trojanhealth.co.za
#
1
HOME
FITNESS
SOUTH AFRICA’S
SINCE
1981
0861 876526
0861 TROJAN
WARRANTY
TROJAN
MY SPACE MY TIME
®
CAUTION
READ ALL PRECAUTIONS AND
INSTRUCTIONS IN THIS MANUAL
BEFORE USING THIS EQUIPMENT.
KEEP THIS MANUAL FOR
FUTURE REFERENCE
INDEX PAGE
1. SAFETY INSTRUCTIONS 3
2. PRE ASSEMBLY CHECK LIST 5
3. HARDWARE LIST 6
4. ASSEMBLY STEPS 8
5. COMPUTER FUNCTIONS 11
6. FITNESS TIPS AND TECHNIQUES 14
7. CONDITIONING GUIDELINES 15
8. WARM-UP AND COOL-DOWN 16
9. FREQUENTLY ASKED QUESTIONS 17
10. PARTS LIST 18
11. EXPLODED DRAWING 19
12. TROJAN 1 YEAR LIMITED WARRANTY 20
13. TROJAN REPAIRS PROCEDURE 21
10205 - 3
1. SAFETY INSTRUCTIONS
It is the sole responsibility of the purchaser of TROJAN products to read the owner’s manual, warning labels and instruct all
individuals, on proper usage of the equipment. Understanding each and every warning to the fullest is important. If any of these
instructions or warnings are unclear please contact Trojan Customer Services on 0861 876 526 (0861 Trojan), within the Republic of
South Africa.
The equipment is only intended for HOME USE and is NOT INTENDED FOR COMMERCIAL, INSTITUTIONAL AND/OR
STUDIO FACILITIES USE.
Contact TROJAN with any questions regarding this classification. It is recommended that all users of TROJAN be informed of the
following information prior to use.
HEALTH WARNING
• Beforestartinganyexerciseorconditioningprogramyoushouldconsultwithyourpersonalphysiciantoseeifyourequirea
completephysicalexam.Thisisespeciallyimportantifyouareovertheageof35orhaveneverexercised,arepregnantorsuffer
from any illness.
• Ifatanytimeduringexerciseyoufeelfaint,dizzyorexperiencepain,stopexercisingimmediatelyandconsultyourphysician.
• To avoidmuscularpainandstrain,begineachworkoutbystretchingandwarmingupandendeachsessionbycoolingdownand
stretching.
ACCESS CONTROL
TROJAN recommends that all fitness equipment be used in a supervised area. It is recommended that the equipment be located in
an access controlled area. Control is the responsibility of the owner. Keep children away from all equipment. Parents or other
supervising adults must provide close supervision of children if the equipment is used in the presence of children.
INSTALLATION
TROJAN recommends that all equipment:
• Besecuredtoorsetuponasolid,levelsurfacetostabilizeandeliminaterockingortippingoverduringtraining.
• Besetupinsideyourhomeawayfrommoistureanddust(theequipmentisnotdesignedforoutdooruse).
• Besetupwithsufcientventilationtoensureproperoperation.
• Besetupwithsufcientspacearoundtheequipmentsothatallexercisescanbecompletedsafely.Itisrecommendedthatthere
shouldbeatleast1mofspacearoundtheequipmentwhereaccessisrequiredtoexercise.Fortreadmillsitisrecommended
thatyouhave2mofspacebehindtherunningdeck.
• Beinstalledbyourteamofinstallers.
PROPER USAGE
• Donotusetheequipmentinanywayotherthanasdesignedorintendedbythemanufacturer.Itisimperativethat
TROJAN equipment is used properly to avoid injury.
• Injuriesmayresultfromexercisingimproperlyorexcessively.
• YourTROJANequipmentshouldonlybeusedbyonepersonatatime.
• Becarefultomaintainyourbalancewhileusing,mounting,dismounting,folding,unfoldingorassemblingyourTROJAN
equipment to avoid injury.
• Donotattempttoadjustanyseats,pedals,handlebarsetc.whileyouareonyourTROJANequipment.
• Servicingotherthantheproceduresinthismanualshouldbeperformedbyanauthorizedservicerepresentativeonly.
• DANGER:Alwaysunplugthepowercordbeforecleaninganyequipmentpoweredbyelectricity.
Main Frame (1)
Front Stabiliser (20)
Rear Stabiliser (2)
Pedal (L,R) (11&12)
Seat Post (48)
Seat (51)
Upright Tube (4 2)
Computer (54)
Handlebar (55)
Transformer (71)
M8 x 70mm Screw (3)-4
Ø8 x Ø19 Arc Washer (4) -12
M8 x 15mm Screw (18) -8
Scew Driver
M8 Cap Nutt (5)-4
Allen Wrench
CAUTION:
Ensure that cables are not damaged
during assembly or when tightening screws.
CAUTION:
Ensure that cables are not damaged
during assembly or when tightening screws.
Recheck
all bolts and nuts are
tightened securely
before using the machine
CAUTION:
Ensure that cables are not damaged
during assembly or when tightening screws.
10205 - 11
10205 - 12
10205 - 13
10205 - 14
6. FITNESS TIPS AND TECHNIQUES
1
2
3
4
5
No. Description Specification Q’ty No. Description Specification Q’ty
1 Main Frame 1 39 Motor Hardness Wire 1350mm 1
2 Rear Stabiliser
Ø60x1.5x500 1 40 Sensor Wire 600mm 1
3 Carriage Bolt M8x70 4 41 Upper Hardness Wire 1200l 1
4 Arc Washer Ø8xØ19x1.5 12 42 Upright Post Ø60 1
5 Nut Cap M8 4 43 Bolt 4x8 4
6 End Cap 2 44 Motor Cable 390mm 1
7 Pulley Ø270mm 1 45 Motor 1
8 Magnet Ø12.5 1 46 Adjust Knob 1
9 Power Cable 800mm 1 47 Bushing
40x80 1
10 Crank 170mmx3pcs 2 48 Seat Post 30x70x1.5x400 1
11 Pedal R JD-22a 9/16’’ 1 49 Washer 3
12 Pedal L JD-22a 9/16’’ 1 50
NylockNut 3
13 HexHeadBolt M8x60 2 51 Seat 805F 1
14 Magnetic Plate 1 52 Foam Grip Ø28.6x3.0x470 2
15 Plate Spring Ø1.5xØ14.5x64 1 53 Handlebar Cap Ø28.6 2
16 NylockNut M8 2 54 Consol SM-1330 1
17 Nut M8 1 55 Handlebar Ø28.6x1040 1
18 Bolt M8x15 8 56 Flywheel Bearing 1
19 Wheel Cap Ø60 2 57 Chain Cover R 388 (R) 1
20 Front Stabiliser
Ø60x1.5x500 1 58 Chain Cover L 388(L) 1
21 Belt J6 430 1 59 One Way Bearings 1
22
NylockNut M10 1 60 Hand Pulse PE18 2
23 Bearings 6000zz 3 61 Bolt M4x16 10
24 Idler Wheel Ø26xØ40x24 1 62 Bolt M4x30 4
25 Idler Spacer Ø10xØ13x10 1 63 Pulse Wire 600mm 2
26 Idler Arm 30x170x5.0 1 64 Bearings 6004 2
27 HexHeadBolt 3/8”x26 1 65 Bearings 6203 1
28 Washer Ø10xØ26x2.0 2 66 Bolt M5x12 4
29 Idler Spring Ø2.6xØ15x57 1 67 Spring Washer 3
30 NylockNut 3/8” 1 68 C Clip S17 1
31 Nut 3/8” 1 69 Nut M10 2
32 Washer
Ø8xØ19x1.5 2 70 Pulley
Axle 17x197 1
33 Washer Ø10xØ19x1.5 1 71 Adapter 220v 1
34 BC Nut 3/8” 1 72 Outside Bearing Collar 1
35 Flywheel Spacer
Ø10xØ13x4 1 73 Big Washer 1
36 Flywheel Ø188.57kgs 1
37 FlywheelAxle Ø9.98x126 1
38 Greased Bearing Ø8xØ13x6 1
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22

Trojan Velocity 410 Owner's manual

Trojan
Brand
Trojan
Model
Velocity 410
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents