AEV Four Light Harness Installation guide

INSTALLATION GUIDE

FOUR LIGHT HARNESS

FOR RAM TRUCK

AEV30475AA

Last Updated: 08/15/23

PLEASE READ ENTIRELY BEFORE YOU START

To guarantee a quality installation, we recommend reading these instructions thoroughly

before beginning any work. These instructions assume a certain amount of mechanical

ability and are not written nor intended for someone not familiar with auto repair.

AMERICAN EXPEDITION VEHICLES

1. The harness runs behind the driver’s side front tire, then runs along where the grill and radiator meet.

2. Use the provided edge clip ties to mount the harness to the frame.

AMERICAN EXPEDITION VEHICLES

3. When adding the bumper to the vehicle use the christmas tree clip to feed into the lowest hole in the

bumper assembly.

4. Ground the harness to this position near the battery and continue to run the wire around the back of the

battery in order to connect it to the Ram aux plug.