Auber Instruments CU005E Quick start guide

  • Hello! I'm a chat assistant and I have reviewed the Quick Guide for the Cube 4E temperature controller, which incorporates EZBoil temperature controller. This document provides specifications and instructions on how to connect power, temperature sensors, and auxiliary devices. I also noted key features such as power switching and the presence of temperature controller. I'm ready to answer any questions you might have about it!
  • What is the maximum power input for the Cube 4E?
    What type of temperature sensor is used with the Cube 4E?
    What is the purpose of the Main Switch?
    What does the green LED indicator 'OUT' on the EZBoil controller show?
AuberInstruments,Inc.  www.auberins.com
Page1of2
Copyright2007‐2022,AuberInstruments.AllRightsReserved.
Nopartofthismanualshallbecopied,reproduced,ortransmittedinanywaywithouttheprior,writtenconsentofAuberInstruments.Auber
Instrumentsretainstheexclusiverightstoallinformationincludedinthisdocument.
Quick Guide for Cube 4E
Version1.1(3/18/2022)
Specifications
PowerInput 240VAC,30AMax
PowerInputConnector L14‐30P,MaleReceptacle(L1,L2,N,G)
PowerOutput(toheater) 240VAC,30AMax
PowerOutputConnector(toheater) L6‐30R,FemaleReceptacle(L1,L2,G)
Switchfor240VSocket 32A,2‐pole,CircuitBreaker
Switchfor120VAUXSocket SW4(10AMax)
TemperatureController EZBoil®(DSPR120,orDSPR320A)
TemperatureProbe PT100RTDsensor
ProbeConnectoronPanel XLRCON‐M,black
Power‐switchingDevice 40AACsolid‐staterelay(SRDA40)
Dimensions(WxHxD) 9.1x7.9x8.9inches(230x200x225mm)
Weight 7.9lbs.(3.6Kg)
WorkingEnvironment 0°C‐50°C,<85%RH
Identify the Parts
Frontpanel Backpanel
Figure1.ThefrontandthebackpanelofCube4E.
(Connectorwiring:G‐ground,W‐neutral,X–Line1,Y–Line2)
AuberInstruments,Inc.  www.auberins.com
Page2of2
Basic Operations
1. PowerInput.ThisCubeunitrequiresUS240VpowerwithL1,L2,neutral,andground.Please
ensurethewiringintheL14‐30Rpowerinputconnector(plug)iscorrect.
2. TemperatureController.TheEZBoil®temperaturecontrollerwillturnononcetheCubeis
connectedtoa240Vpower.ConsulttheusermanualoftheEZBoilcontrollertogetfamiliar
withhowtoprogramthecontroller.
3. SensorInput.ConnectaPT100RTDsensortotheXLRCON‐Mportonthebackpanelofthe
Cubeunit.Thecontrollershouldshowcurrenttemperaturereadingfromthesensor.Beforea
PT100RTDsensorisconnected,thecontrollerwillshowerrorcode“ORAL”and“932”
alternatively.
4. OutputIndicator.OntheEZBoilcontroller,thegreenLEDindicator“OUT”showsthepower
outputstatus.
5. AUXOutputSockets.TheAUX1socketandAUX2socketwillsupply120Vpowerifthe
correspondingAUXswitchisturnedtotheONposition.TurnAUXswitchestotheOFFposition
ifthese120Vsocketsarenotinuse.
6. MainSwitch.TheMainSwitch(32A2‐polecircuitbreaker)controlsthepowertotheHEATER
socket(L6‐30R).FliptheMainSwitchtotheONpositionwillenablethe240Vpowertothe
HEATERsocket.Insituationswhereyouneedtocutoffpowertothe240Vheatersocketor
whenthesolid‐staterelayisshorted,flipthisMainSwitchtoOFFposition.
(End)
AuberInstruments
5755NorthPointParkway,Suite99
Alpharetta,GA30022,USA
www.auberins.com
E‐mail:[email protected]Tel:770‐569‐8420
Copyright2007‐2022,AuberInstruments.AllRightsReserved.
Nopartofthismanualshallbecopied,reproduced,ortransmittedinanywaywithouttheprior,writtenconsentofAuberInstruments.Auber
Instrumentsretainstheexclusiverightstoallinformationincludedinthisdocument.
/