2. ROOMS TO GO
  3. 71563122

ROOMS TO GO 71563122 Assembly Instructions

  • Hello, I'm your chat assistant. I've reviewed the assembly instructions for the MONTARA SWIVEL Club Chair. This document includes a parts list, step-by-step assembly instructions, and key safety warnings, such as the weight capacity and cleaning guidelines. I'm ready to answer your questions about the assembly of your new chair.
  • What is the weight capacity of the chair?
    What type of cleaning liquid should be avoided?
    Is it OK to assemble if some parts are missing?
Assembly Instructions
Identify All Parts Packed In The Carton Against The Parts List. Remove All
Protective Materials.Place Parts On A Non-abrasive Surface To Avoid
Scratching.Do Not Attempt Assembly If Any Parts Are Missing Or Damaged.
Warning: Please Do Not Use Acid Or Alkaline Washing Liquid To Clean The Product.
Chairs have a 300 lbs weight capacity.
Assemble The Product As Below Shown Step By Step
Part List
GLA-63127-31KD
Made in China
1
NO. SKETCH
DESCRIPTION
QTY NO.
SKETCH
DESCRIPTION QTY
A
Seat Frame
1
AA Bolt
(M8*55) 4
B
Swivel Base
1
BB Steel Washer
(Φ12.5*Φ8.5*2) 8
C Seat Cushion
1
CC Steel Washer
(Φ16*Φ8.2*1.0) 8
D Back Cushion
1
DD Steel Washer 4
E Foot Glider
4
EE Nut 4
FF Bolt Cap
(19*16.5*11.5) 4
GG
Bolt Cap
(19*16.5*17) 4
HH Wrench 2
MONTARA SWIVEL CLUB CHAIR
71563122
SKU#
STEP 1
Hand-tighten nuts 3-4 revolutions only. After attaching all bolts, adjust all parts at
the correct position. Then tighten all bolts and nuts. Do Not Over Tighten.
STEP 2
Turn the chair right side up. Adjust the pre-installed foot glider(E) at the bottom of
swivel base until the chair is level with the ground securely, your chair is ready for
use.
2
A
B
D
C
E
A
B
СС
EE
BB
DD
GG
AA
BB
DD
CC
FF
/