inVue S3100V Vertical Wireless Wall Stand Sensor and Adapter User manual

  • Hello! I've reviewed the instructions for the InVue Wall Stand Sensor & Adapter, specifically models DCD305-B and DCD306-W. This document outlines the steps for installation, including how to use the adapter, wall stand, and magnet key with the S3100V sensor. I'm ready to answer any questions you have about the setup process or features described in the instructions.
  • What is the purpose of the magnet key?
    What should I do after placing the adapter to the stand?
    Which sensor is compatible with the wall stand?
S3100V
Vertical Wireless Wall Stand Sensor &
Adapter
DCD305-B & DCD306-W
Ensure that the narrow part of the
connector is facing upwards as
shown below.
2
Insert the adapter into the previously
installed OnePOD stand.
1
Place a magnet key (DBG400)
onto the lockdown feature on the
OnePOD stand. Turn the magnet key
90 degrees clockwise to lock the
adapter to the stand.
33
44 Align the adapter to the opening
on the back of the wall stand. Ensure
that the rails in the inside of the
wall stand engage with the guides on
the adapter.
Slide the wall stand down on the
adapter.
5Place the display device with an
S3100V sensor installed onto the wall
stand.
6
Note: Consult the instructions included with the
S3100V Sensor for more information on installing
the sensor.
© 2021 InVue Security Products Inc. All rights reserved.
InVue is a registered trademark of InVue Security Products.
SD0859 Rev1 09/16/21
www.invue.com
NA / LATAM // 704.752.6513 888.55.INVUE
EMEA // +31.23.8900150
APAC // +852.3127.6811
/