Displays2go FD30S42BKC, FD24R42BKC, FD24S42BKC, FD30R42BKC Assembly Instructions

Hello! I'm a chat assistant that has analyzed the assembly instructions for the DISPLAYS2GO Bar Table models FD24 and FD30. The document includes an exploded view and step-by-step instructions to guide you through the assembly process including attaching the glides, column, plate and wooden top. I'm ready to answer any questions you may have about setting up your new bar table.
What tool is needed for assembly?

What should I do before assembling?

How many glides are there?

BAR TABLE

PARTS

A1 pc

HARDWARE BAG

H1 1 pc

B

Bottom

Base screw

1 pc

Bottom Base

Column

Attention: Before you start assembling your table top; please prepare a soft surface work area on the floor. The only tool

you will need is a screwdriver. Carefully remove all hardware from packaging and place the hardware parts on the soft work

area where they will not come in contact with the laminated wood components. To avoid damage to the laminated wood

surfaces, keep hardware parts separated until they are needed for assembly.

C1 pc

Plate

H3 2 pcs

Plate Nut

D1 pc

Table Top

H2 4 pcs

Glides H4 8 pcs

Wood

Screw

A

B

C

D

Please use 4 pre-drilled holes on the reverse

side to install

H1

H2

H3

H4

Fig. (1)

Fig.(2)

Fig. (3)

ASSEMBLY INSTRUCTIONS

Step 1: Attach glides (H2) to

bottom base (A).

Step 2: Attach column (B) to

bottom base using bottom base

screw (H1).

Step 5: Attach table top (D) to Plate by inserting wood

screws (H4) through holes in plate and into table top.

FD24, FD30 CUSTOMIZED COUNTERTOP SERIES

If you have any questions regarding our products, please contact D2G customer service.

Tighten the screw to

fix the purse hook

Step 3: Slide purse hook over column

and secure by tightening screw.

Step 4: Attach plate (C) to column

using plate nuts (H3).

/

Other documents