Displays2go FD24R42BKC Assembly Instructions

Displays2go
Brand
Displays2go
Model
FD24R42BKC
Type
Assembly Instructions

This manual is also suitable for

BAR TABLE
PARTS
A1 pc
HARDWARE BAG
H1 1 pc
B
Bottom
Base screw
1 pc
Bottom Base
Column
Attention: Before you start assembling your table top; please prepare a soft surface work area on the floor. The only tool
you will need is a screwdriver. Carefully remove all hardware from packaging and place the hardware parts on the soft work
area where they will not come in contact with the laminated wood components. To avoid damage to the laminated wood
surfaces, keep hardware parts separated until they are needed for assembly.
C1 pc
Plate
H3 2 pcs
Plate Nut
D1 pc
Table Top
H2 4 pcs
Glides H4 8 pcs
Wood
Screw
A
B
C
D
Please use 4 pre-drilled holes on the reverse
side to install
H1
H2
H3
H4
Fig. (1)
Fig.(2)
Fig. (3)
ASSEMBLY INSTRUCTIONS
Step 1: Attach glides (H2) to
bottom base (A).
Step 2: Attach column (B) to
bottom base using bottom base
screw (H1).
Step 5: Attach table top (D) to Plate by inserting wood
screws (H4) through holes in plate and into table top.
FD24, FD30 CUSTOMIZED COUNTERTOP SERIES
If you have any questions regarding our products, please contact D2G customer service.
Tighten the screw to
fix the purse hook
Step 3: Slide purse hook over column
and secure by tightening screw.
Step 4: Attach plate (C) to column
using plate nuts (H3).
  • Page 1 1

Displays2go FD24R42BKC Assembly Instructions

Displays2go
Brand
Displays2go
Model
FD24R42BKC
Type
Assembly Instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents