2. Edelbrock
  3. Off-Road Carburetor Needle and Seat #1465 Size .0935 (Pair)

Edelbrock Off-Road Carburetor Needle and Seat #1465 Size .0935 (Pair), 1465, 14661466 User manual

  • Hello! I've reviewed the installation instructions for the Edelbrock Performer Series 1465 Off-Road Needle & Seat Assembly. This document details the replacement process and includes a specific 7/16" setting for off-road float level. I'm happy to answer your questions about this product.
  • What is the catalog number for the Off-Road Needle & Seat Assembly?
    What is the recommended off-road float level?
    Should I press the needle into the seat when adjusting the float level?
®
Off-Road Needle & Seat Assembly
for Performer Series Carburetors
Catalog # 1465
Installation Instructions
)Please study these instructions carefully before installing your Off-Road needle & seat assembly. If you have any
questions or problems, do not hesitate to contact our Technical Hotline at: (800) 416-8628 from 7:00 am to 5:00
pm, Monday through Friday, Pacific Standard Time or e-mail us at: [email protected].
)Use Owner's Manual supplied with carburetor for disassembly and reassembly.
)Remove original needle and seat assembly and replace with #1465 (Figure 1). To reset float level, see Figure 2 for proper
offroad setting (7/16").
OFF-ROAD FLOAT LEVEL
With bowl cover inverted, bowl cover gasket in place, and
weight of float seating needle, there should be 7/16" between
top of each float and bowl cover gasket (at outer end). The
sides of floats should be parallel to the outer edge of the bowl
cover. To adjust, bend float lever.
CAUTION! DO NOT PRESS NEEDLE INTO SEAT WHEN
ADJUSTING FLOAT LEVEL.
Brochure #63-0162
© 2002 Edelbrock Corporation
Rev. 12/02
Needle and Seat assembly
BEND HERE MEASURE AT
OUTSIDE END
7/16"
Figure 1
Figure 2
/