The FLUTTER DEPTH & SPEED controls let you simulate that great
tape-delay “warbled” effect, while the MODULATION button subtly
alters the character of your delay.
Note: The INPUT LEVEL knob on the side of your Reptile eliminates
overdrive distortion caused by too high an input signal. Keep it set
just below where the red light comes on.
Technical specs:
Controls: ON/OFF, ECHO, REPEAT, TIME, LEVEL, FLUTTER DEPTH AND SPEED,
MODULATION and INPUT LEVEL
Connections: INPUT, OUTPUT, power supply
Power supply: 9V DC
Power consumption:
120 mA
Size:
Box: 100 x 120 x 35 mm. Switches/knobs on top: 16 mm.
Feet on bottom: 3 mm