Kenmore 66517702K600 Installation guide

Brand: Kenmore

Model: 66517702K600

Category: Dishwashers

Type: Installation guide

This manual is also suitable for

Kenmore 66517702K600: This portable dishwasher can be connected to your sink faucet for operation and features a variety of wash cycles to meet your dishwashing needs. The dishwasher includes four casters for easy mobility and can be rolled into place for use and rolled out of the way when not in use. It has a self-contained design and does not require permanent plumbing connections. The dishwasher features a spacious interior with two racks to accommodate a variety of dishware, glasses, and cookware, and it uses a combination of water and detergent to clean dishes.

Installation instructions

Portable ishwasher

Instruccionesde Instalaci6n

Lavavaj las Portbtii

instructionsd'installation

Lave-vaissellemobi

....ii_,i_!!!ii_iii_!i@O,ii_{_O_,_iiij:@_ii_i_iilS

Dishwasher Safety. ........................................................................ 1

Installation Requirements .............................................................. 2

Tools and Materials Needed .......................................................... 2

Parts Supplied ............................................................................... 2

Location Requirements .................................................................. 2

Water Supply Requirements .......................................................... 2

Electrical Requirements ................................................................. 2

Caster Installation .......................................................................... 2

Faucet Preparation ........................................................................ 3

Check Operation ............................................................................ 3

iMPORTANT: Read and save these instructions

for the local eJectrical inspector's use.

Doing so wiJJ:

o make installation easier.

o help you in the future if you have questions.

o help if you have an electrical inspection.

Call your Sears store or service center when you have

questions or need service. When you call, you will need the

dishwasher model and serial numbers.

Model number:

Serial number:

8575271

DISHWASHERSAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."

These words mean:

You can be killed or seriously injured if you don't immediately

follow instructions.

You can be killed or seriously injured if you don't follow

instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can

happen if the instructions are not followed.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using the dishwasher, follow basic precautions, including the following:

[] Read all instructions before using the dishwasher.

[] Use the dishwasher only for its intended function.

[] Use only detergents or rinse agents recommended for use

in a dishwasher, and keep them out of the reach of children.

[] When loading items to be washed:

1) Locate sharp items so that they are not likely to damage

the door seal; and

2) Load sharp knives with the handles up to reduce the risk

of cut-type injuries.

[] Do not wash plastic items unless they are marked

"dishwasher safe" or the equivalent. For plastic items not so

marked, check the manufacturer's recommendations.

[] Do not touch the heating element during or immediately

after use.

[] Do not operate the dishwasher unless all enclosure panels

are properly in place.

[] Do not tamper with controls.

[] Do not abuse, sit on, or stand on the door, lid, or dish racks

of the dishwasher.

[] To reduce the risk of injury, do not allow children to play in

or on the dishwasher.

[] Under certain conditions, hydrogen gas may be produced in

a hot water system that has not been used for two weeks or

more. HYDROGEN GAS IS EXPLOSIVE. If the hot water

system has not been used for such a period, before using

the dishwasher turn on all hot water faucets and let the

water flow from each for several minutes. This will release

any accumulated hydrogen gas. As the gas is flammable,

do not smoke or use an open flame during this time.

[] Remove the door or lid to the washing compartment

when removing an old dishwasher from service or

discarding it.

SAVE THESE INSTRUCTIONS

You need to:

* Observe all governing codes and ordinances.

,, Prepare dishwasher and faucet for use as specified in these

instructions.

,, Have everything you need to properly install the dishwasher.

,, Contact a qualified installer to insure that electrical and

plumbing meet all national and local codes and ordinances.

iNSTALLATiON REQUIREMENTS

Tools and materials needed:

Gather the required tools and parts before starting

installation. Read and follow the instructions provided with

any tools listed here.

o Pliers

o Small hammer

Parts supplied:

o Faucet adapter kit, Part No. 3374592

o 4 casters

o Literature package

Make sure all these parts were included in the dishwasher. Close

and latch dishwasher door. See parts list for accessories available

for your dishwasher.

Location Requirements:

Check location where dishwasher will be used.

The location must provide:

,, Sink or laundry tub that can drain water at a minimum carry-

away capacity of 7 gallons (26 liters) per minute.

,, Top of sink or laundry tub that is at least 27 inches (68.6 cm)

high and not higher than 48 inches (122 cm) from the bottom of

dishwasher.

,, Floor support for dishwasher weight of 180 pounds (81.6 kg).

,, Grounded electrical outlet.

,, Hot water faucet or hot and cold single-spout water faucet within

30 inches (76.2 cm) of the back of dishwasher.

Water supply requirements:

You must have:

, A hot water line with 20-120 psi (138-862 kPa) water pressure.

,120°F (49°C) water at dishwasher.

Electrical requirements:

Contact a qualified electrician.

Assure that the electrical installation is adequate and in

conformance with all national and local codes and ordinances.

You must have:

,, 120-volt, 60 Hz, AC-only, 15 or 20 amp., fused electrical supply.

,, Mating grounded electrical outlet.

We recommend:

,, A time-delay fuse or circuit breaker.

,, A separate circuit, serving only this appliance.

Excessive Weight Hazard

Use two or more people to move and install

dishwasher.

Failure to do so can result in back or other injury.

1. Put two corner posts (A) on the floor behind the dishwasher.

2. Grasp sides of dishwasher door frame (B) and put dishwasher

on its back.

3. Firmly push casters (C) into holes at corners of dishwasher as

shown. Pull on each caster to check that casters are snug.

NOTE: It may be helpful to place a piece of wood against the

caster wheels and lightly tap the wood with a hammer.

I incorrect

4. Stand dishwasher upright. Open door and remove any

shipping pieces (D) from racks. Close dishwasher door and

latch shut.

NOTE: Packaging may vary.

1. Remove screen holder or aerator (A), screen (B) and washer

(C), from end of faucet (D).

2. Use faucet adapter that came with your dishwasher to

change the faucet where dishwasher will be used.

Faucets with external threads:

Insert both screens (E) and thin washer (F) into faucet adapter (G).

Attach adapter onto end of faucet (D). The thick washer is not used.

F m

Faucets with internal threads:

Insert both screens (E), the thin washer (F) and then the thick

washer (H) into faucet adapter (G). Attach adapter onto end of

faucet D. Both washers need to be used.

H__

F__

G--

Other faucet types:

See your local Sears store or service center for specific

adapter kit.

NOTE: If dishwasher will be used at a faucet equipped with a

spray hose attachment, constant water pressure may affect

the spray hose. The spray hose should be permanently

disconnected or replaced with a high-pressure hose.

1. Read the Use and Care Guide that came with your dishwasher.

2. Check that you have installed all parts and did not skip any

steps.

3, Check that you have all the tools you used.

4. Check that you have correct electrical supply and a properly

grounded outlet.

5, Turn on the hot water faucet until water is hot. Turn faucet off.

6. Pull inlet/drain hose (A) from the storage compartment.

7. Pull down on locking collar (B) and push hose connector (C)

over end of faucet adapter (D). It will snap into place.

8. Release locking collar.

ElectricalShock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

Pull power supply cord (E) from the storage compartment and

plug it into the grounded 3 prong outlet (F).

10. Open dishwasher door and spin the spray arm (G) to check

for movement.

19. Pull down on locking collar (B) and hold while removing hose

connector from faucet.

20. Turn hose connector upside down and empty water from

inside connector.

21. Insert inlet/drain hoses and hose connector (C) into storage

compartment (H).

if the dishwasher does not operate:

First try the solutions suggested here to possibly avoid the

cost of a service call.

* Has the circuit breaker tripped or the house fuse blown?

* Is the door closed tightly and latched?

,,Has the cycle been set correctly to start the dishwasher?

®Is the water turned on?

If none of these work, call 1-800-4MY-HOME.

11. Close and latch door.

12. Turn hot water faucet to fully open position.

13. Start dishwasher and allow it to complete a short cycle.

14. Check for leaks around the door and mounting gasket, and at

the hose connection.

15. At the end of the cycle, open dishwasher door and check that

all water was drained from inside dishwasher.

16. Unplug power supply cord (E) and insert cord into storage

compartment (H).

17. Turn water faucet off.

18. Press bleeder button (I) on hose connector (C) to release

water pressure.

Page is loading ...

PartNo.8575271

PiezaNo.8575271

PieceN°8575271

PrintedinU.S.A.

ImpresoenlosEE.UU.

ImprimeauxE.-U.

02/2006

Kenmore 66517702K600 Installation guide

Brand: Kenmore

Model: 66517702K600

Category: Dishwashers

Type: Installation guide

This manual is also suitable for

Download PDF

report

in other languages

français: Kenmore 66517702K600 Guide d'installation
español: Kenmore 66517702K600 Guía de instalación

Kenmore 66517702K600 Installation guide

This manual is also suitable for

Kenmore 66517702K600 Installation guide

in other languages

Related papers

Other documents