Everbilt 33865 Installation guide

SINGLE LEVER HANDLE FOR DELTA®

INSTALLATION INSTRUCTIONS 1006964458

Tools Required:

Allen Wrench

Screwdriver

Optional:

Handle Puller

Handle

Set Screw

(included,

pre-installed)

Single Handle with Set Screw

Installation Instructions

1. Remove the old handle:

Using an allen wrench, turn counter-clockwise to loosen the

handle set screw. Lift or pull handle to remove.

(If the old handle is difficult to remove, use a screwdriver to pry

the bottom of the handle on both sides, to rock on and off,

or use a handle puller if needed.)

2. Replace handle:

Place new handle on valve stem or cartridge.

Using an allen wrench, turn clockwise to tighten the

pre-installed set screw and secure handle.