2. Everbilt
  3. 33865

Everbilt 33865 Installation guide

  • Hello! I have reviewed the installation instructions for the Handle, which details the process of replacing a single lever handle. The document outlines the tools needed and provides step-by-step guidance on both removing the old handle and installing the new one. I am ready to answer any questions you might have about this process or the handle itself, based on the provided document.
  • What tools are required for installation?
    How do I remove the old handle?
    How do I install the new handle?
SINGLE LEVER HANDLE FOR DELTA®
INSTALLATION INSTRUCTIONS 1006964458
Tools Required:
Allen Wrench
Screwdriver
Optional:
Handle Puller
Handle
Set Screw
(included,
pre-installed)
Single Handle with Set Screw
Installation Instructions
1. Remove the old handle:
Using an allen wrench, turn counter-clockwise to loosen the
handle set screw. Lift or pull handle to remove.
(If the old handle is difficult to remove, use a screwdriver to pry
the bottom of the handle on both sides, to rock on and off,
or use a handle puller if needed.)
2. Replace handle:
Place new handle on valve stem or cartridge.
Using an allen wrench, turn clockwise to tighten the
pre-installed set screw and secure handle.
/