EM901X
User Manual
What's inside
Accessories composition
1. EM901X Light-weighted Mouse
2. 2.4G Receiver
3. Receiver Bottom Case
4. RGB Charging Base
5. TYPE-C cable
Basic Information
Button instruction
1. NANO receiver
2. Cable
3. Scroll button
4. DPI button
5. Left button
6. Right button
7. Forward button
8. Backward button
10. Backlight ON/OFF
9. Power ON/OFF
2
1
6
5
910
3
4
8
7
Combination keys
Further Knowing
Mouse parameter
Press wheel button
+ right button for 3s,
and white indicator
light will be on.
DPI indicator light
White light flashes one time
(Power-saving mode): 125Hz
White light flashes twice
(Office mode): 250Hz
White light flashes three times
(Gaming mode): 500Hz
White light flashes four times
(E-sport mode): 1000Hz
500/1000Hz
Working Mode
Report Rate
Indicator Light
DPI
Battery Capacity
Power Consumption
Standby Mode
Charging time
2.4G wireless power saving
mode / office mode
2.4G wireless gaming
mode / e-sport mode
125/250Hz
600/1200/2400/3600/4800/10000dpi
930mAh
30mAh (MAX)
5.5mA(after 20 minutes)
4 hours
Service durationv
40hours(light off ) 20hours(light on)
Indicator light will flash in red in 1Hz for reminding when voltage is lower than 10%
Wireless
Mode
Further Knowing
Product Name
IC
Resolution
Weight
Charging Current
Max Speed
Max Acceleration
Refresh Rate
DPI value
DPI color
100 IPS
20G
6000 fps
600/1200/2400/3600/4800/10000dpi
Red/Blue/Green/Yellow/Orange/Purple
Plugged cable, mouse is default in wired mode and begins charging. 0-10% charged
mouse lights in red, 10-90% in yellow, and 90%-100% in green
EM901X (Dual Mode)
ATG 4090
85g±5g
230mA
125/250/500/1000Hz
(Default :1000Hz)
Wired
Mode
Mouse installation & usage
Laptop
PC
PC
By default DPI is adjustable in 6 steps by DPI+/- button.
Red (600dpi) Blue (1200dpi)
Green (2400dpi) Yellow (3600dpi)
Orange (4800dpi) Purple (10000dpi)
Colors above are default color
Code matching:
1. Turn on mouse
2. Press left/middle/right button (as picture shows) at the same time to
enter matching mode and at this time Logo indicator light will flash in
yellow.
3. Plug receiver into computer USB port
4. Put mouse close to receiver and wait for code matching finishing.
When code is matched, LOGO indicator light will switch to constant color
based on current DPI value.
Professional operations
DPI value/lighting color
5.Driver
Download the driver from DAREU website if needed.
1
Driver interface
2
Marco interface
How to use driver
/