D-Link DSL-2750U User manual

DSL-2750U/TK

User Manual

DSL-2750U User Manual

i

Contents

1 Safety Precautions.............................................................................................1

2 Introduction ........................................................................................................2

2.1 Packing List...........................................................................................2

2.2 LEDs and Interfaces..............................................................................2

2.3 System Requirements...........................................................................6

2.4 Features ................................................................................................6

3 Hardware Installation .........................................................................................8

3.1 Choosing the Best Location for Wireless Operation..............................8

3.2 Connecting the Router...........................................................................8

4 About the Web Configurator...............................................................................9

4.1 Access the Router.................................................................................9

4.2 Setup................................................................................................... 11

4.2.1 Wizard....................................................................................... 11

4.2.2 Internet Setup...........................................................................17

4.2.3 3G Internet Setup .....................................................................26

4.2.4 Wireless Connection.................................................................29

4.2.5 Local Network...........................................................................33

4.2.6 Time and Date ..........................................................................36

4.2.7 Print Server...............................................................................37

4.2.8 Logout.......................................................................................38

4.3 Advanced.............................................................................................38

4.3.1 Wireless Settings......................................................................38

4.3.2 Port Forwarding........................................................................45

4.3.3 Port Triggering..........................................................................48

4.3.4 DMZ..........................................................................................50

4.3.5 Parental Control........................................................................51

4.3.6 Filtering Options........................................................................55

4.3.7 DNS..........................................................................................61

4.3.8 Dynamic DNS...........................................................................62

4.3.9 Storage Service........................................................................64

4.3.10 Multicast..............................................................................66

4.3.11 Network Tools......................................................................67

4.3.12 Routing................................................................................79

4.3.13 RIP ......................................................................................82

DSL-2750U User Manual

ii

4.3.14 MultiNat...............................................................................83

4.3.15 Schedules............................................................................84

4.3.16 Logout .................................................................................85

4.4 Maintenance........................................................................................85

4.4.1 System......................................................................................85

4.4.2 Firmware Update......................................................................86

4.4.3 Access Controls........................................................................87

4.4.4 Diagnostics...............................................................................90

4.4.5 System Log...............................................................................91

4.4.6 Logout.......................................................................................92

4.5 Status...................................................................................................92

4.5.1 Device Info................................................................................92

4.5.2 Wireless Clients........................................................................94

4.5.3 DHCP Clients............................................................................94

4.5.4 Logs..........................................................................................94

4.5.5 Statistics....................................................................................95

4.5.6 Route info .................................................................................97

4.5.7 Logout.......................................................................................97

5 FAQs ................................................................................................................98

DSL-2750U User Manual

1

1 Safety Precautions

Follow the following instructions to prevent the device from risks and damage

caused by fire or electric power:

 Use volume labels to mark the type of power.

 Use the power adapter packed within the device package.

 Pay attention to the power load of the outlet or prolonged lines. An

overburden power outlet or damaged lines and plugs may cause electric

shock or fire accident. Check the power cords regularly. If you find any

damage, replace it at once.

 Proper space left for heat dissipation is necessary to avoid damage caused

by overheating to the device. The long and thin holes on the device are

designed for heat dissipation to ensure that the device works normally. Do

not cover these heat dissipation holes.

 Do not put this device close to a place where a heat source exists or high

temperature occurs. Avoid the device from direct sunshine.

 Do not put this device close to a place where it is over damp or watery. Do

not spill any fluid on this device.

 Do not connect this device to any PCs or electronic products, unless our

customer engineer or your broadband provider instructs you to do this,

because any wrong connection may cause power or fire risk.

 Do not place this device on an unstable surface or support.

DSL-2750U User Manual

2

2 Introduction

The DSL-2750U is a highly integrated ADSL2/2+ Integrated Access Device. It

provides DSL uplink, 3G Internet setup, Ethernet LAN and wireless LAN services.

The wireless LAN is complied with the IEEE802.11b/g /n standards and supports

2T2R. It is usually prefered to provide high access performance applications for

the individual users, the SOHO, the small enterprise and so on.

2.1 Packing List

 1 x DSL-2750U Router

 1 x 3-Pin Power supply /Lightning protection unit

 1 x Splitter

 1 x micro filter

 1 x Installation CD

 2 x RJ11 Phone Cable

 1 x RJ45 Ethernet cable

 1 x Documents

2.2 LEDs and Interfaces

Note: The figures in this document are for reference only.

DSL-2750U User Manual

Front Panel

Figure 1 Front panel

The LED indicators are as follows from left to right: Power, LAN1/2/3/4, WLAN,

USB, DSL, Internet. The WPS indicator is on the side panel.

The following table describes the LEDs of the device.

LED Color Status Description

Off The power is off.

Green On The power is on and the initialization is

normal.

On The device is initiating.

Power

Red Blinks The firmware is upgrading.

Off No LAN link.

Blinks Data is being transmitted through the

LAN interface.

LAN

1/2/3/4 Green

On The connection of LAN interface is

normal.

3

DSL-2750U User Manual

4

LED Color Status Description

Blinks Data is transmitted through the WLAN

interface.

On The connection of WLAN interface is

normal.

WLAN Green

Off The WLAN connection is not established.

On The connection of 3G or USB flash disk

has established.

Blink Data is being transmitted.

USB Green

Off No signal is detected.

Off Initial self-test is failed.

Blinks The device is detecting itself.

DSL Green

On Initial self-test of the unit has passed.

Off The device is under the Bridge mode,

DSL connection is not present, or the

power is off.

Green

On IP is connected and no traffic is detected.

Internet

Red On The device is attempted to become IP

connected, but failed.

Blinks WPS negotiation is enabled, waiting for

the clients.

WPS (on

the side

panel) Green Off Device is ready for new WPS to setup.

DSL-2750U User Manual

Rear Panel

Figure 2 Rear panel

The following table describes the interface of the device.

Interface/Button Description

DSL RJ-11 interface that connects to the telephone set

through the telephone cable.

LAN4/3/2/1 Ethernet RJ-45 interfaces that connect to the Ethernet

interfaces of computers or Ethernet devices.

USB USB port, for connecting the 3G network card or other

USB storage devices.

WIRELESS ON/OFF Button to enable or disable WLAN.

RESET

Reset to the factory defaults. To restore factory defaults,

keep the device powered on and push a paper clip into

the hole. Press down the button for one second, and

then release.

ON/OFF Power on or off.

POWER Interface that connects to the power adapter. The power

adapter output is: 12 V DC 1A.

5

DSL-2750U User Manual

6

WPS (on the side

panel) WPS button to setup connection to client.

2.3 System Requirements

Recommended system requirements are as follows:

 An 10 baseT/100BaseT Ethernet card is installed on your PC

 A hub or switch (attached to several PCs through one of Ethernet

interfaces on the device)

 Operating system: Windows 98SE, Windows 2000, Windows ME,

Windows XP, Windows Vista or Windows 7

 Internet Explorer V5.0 or higher, Netscape V4.0 or higher, or Firefox 1.5 or

higher

2.4 Features

The device supports the following features:

 User-friendly GUI for web configuration

 Compatible with all standard Internet applications

 Industry standard and interoperable DSL interface

 Simple web-based status page displays a snapshot of system configuration,

and links to the configuration pages

 Downloadable flash software updates

 WLAN with high-speed data transfer rates of up to 130 Mbps, compatible

with IEEE 802.11b/g/n, 2.4GHz compliant equipment

 IP routing and bridging

 Asynchronous transfer mode (ATM) and digital subscriber line (DSL)

support

 Point-to-point protocol (PPP)

 Network/port address translation (NAT/PAT)

 Quality of service (QoS)

 Wireless LAN security: WPA, 802.1x, RADIUS client

 Universal plug-and-play(UPnP)

 Print server

 Web filtering

DSL-2750U User Manual

7

 3G Mobile WAN connection

 USB mass-storage, SAMBA

 System statistics and monitoring

DSL-2750U User Manual

8

3 Hardware Installation

3.1 Choosing the Best Location for Wireless Operation

Many environmental factors may affect the effective wireless function of the DSL

Router. If this is the first time that you set up a wireless network device, read the

following information:

The access point can be placed on a shelf or desktop, ideally you should be able

to see the LED indicators in the front, as you may need to view them for

troubleshooting.

Designed to go up to 100 meters indoors and up to 300 meters outdoors,

wireless LAN lets you access your network from anywhere you want. However,

the numbers of walls, ceilings, or other objects that the wireless signals must

pass through limit signal range. Typical ranges vary depending on types of

materials and background RF noise in your home or business.

3.2 Connecting the Router

(1) Connect the DSL port of the router and the Modem port of the splitter with

a telephone cable; connect the phone to the phone port of the splitter

through a cable; and connect the incoming line to the Line port of the

splitter.

The spliiter has three ports:

 LINE: Connect to a wall phone jack (RJ-11 jack)

 Modem: Connect to the Line interface of the router

 PHONE: Connect to a telephone set

(2) Connect the LAN port of the router to the network interface card (NIC) of

the PC through an Ethernet cable (MDI/MDIX).

(3) Plug the power adapter to the wall outlet and then connect the other end of

it to the Power port of the router.

The following figure shows the connection of the Router, PC, and telephones.

DSL-2750U User Manual

4 About the Web Configurator

This chapter describes how to configure the Router by using the Web-based

configuration utility.

4.1 Access the Router

Configuring IP Address of the Network Card

Configure TCP/IP properties of your network card to Obtain an IP address

automatically from modem, or set the IP address of the computer with the

same network mask of the modem.

For example, if the IP address of Router is 10.0.0.2/255.255.255.0, you can set

the IP address of the computer to 10.0.0.x/255.255.255.0. The range for x is from

3 to 254.

The following is the detailed description of accesing the device for the first time.

9

DSL-2750U User Manual

Step 1 Open the Internet Explorer (IE) browser and enter http://10.0.0.2 .

Step 2 The Login page shown in the following figure appears. Enter the user

name and password.

 The user name and password are admin and admin

respectively.

If you log in as the super user successfully, the page shown in the following figure

appears.

If the login information is incorrect, click Try Again in the page that pops up to log

in again.

10

DSL-2750U User Manual

4.2 Setup

4.2.1 Wizard

Wizard enables fast and accurate configuration of Internet connection and other

important parameters. The following sections describe these various

configuration parameters.

When subscribing to a broadband service, you should be aware of the method,

by which you are connected to the Internet. Your physical WAN device can be

Ethernet, DSL, or both. Technical information about the properties of your

Internet connection is provided by your Internet service provider (ISP). For

example, your ISP should inform you whether you are connected to the Internet

using a static or dynamic IP address, or the protocol, such as PPPoA or PPPoE,

that you use to communicate over the Internet.

Step 1 Choose Setup > Wizard. The page shown in the following figure

appears.

Step 2 Click Setup Wizard. The page shown in the following figure appears.

11

DSL-2750U User Manual

Step 3 There are five steps to configure the device. Click Next to continue.

Step 4 Change Device Login Password.

The default password of admin account is "admin", in order to secure your

network, please modify the password. Note: Confirm Password must be the

same as "New Password". Of course, you can click Skip to ignore the step.

Step 5 Set the time and date.

12

DSL-2750U User Manual

Step 6 Configure the Internet connection.

Select the country and ISP. Set the VPI and VCI. If you fail to find the

country and ISP from the drop-down lists, select Others. Click Next. If

the Protocol is PPPoE or PPPoA, the following page appears.

13

DSL-2750U User Manual

In this page, enter the user name and password provided by your ISP.

If the Protocol is Dynamic IP or Bridge, the page shown in the following figure

appears.

If the Protocol is Static IP, the page shown in the following figure appears.

14

DSL-2750U User Manual

Enter the IP Address, Subnet Mask, Default Gateway, and Primary DNS

Server. Click Next. The page shown in the following page appears.

15

DSL-2750U User Manual

Step 7 Configure the wireless network. Enter the information and click Next.

Step 8 Completed And Apply. Click Apply to apply current settings and

finished the setup of the DSL-2750U router.Click Back to review or

modify settings.

16

DSL-2750U User Manual

Note:

In each step of the Wizard page, you can click Back to review or

modify the previous settings. Click Cancel to exit the wizard page.

4.2.2 Internet Setup

Choose Setup > Internet Setup. The page shown in the following figure appears.

In this page, you can configure the WAN interface of the device.

17

Page is loading ...

D-Link DSL-2750U User manual

D-Link DSL-2750U User manual

Related papers

Other documents