Bluetooth Sunglasses
User Manual
OVERVIEW
OPERATIONAL INSTRUCTIONS
Power On:
V1.0
PRODUCT SPECIFICATION
Model
Bluetooth Version
Bluetooth Protocol
Distance
Music playing time
Phone call time
CW3-22003
V5.1
A2DP/AVCTP/AVDTP/AVRCP/HFP/SPP
Frequency level 2.402GHz - 2.480GHz
10M
6-7h
7h
Charging volt
Charging time
Standby time
Battery
Weight
Shell material
Lens material
Charging port
5V
2h
200h
450833 3.7V 100mAh*2
38.5g
PC+TR90
PC
Magnetic suction
UV400
polarized lens
Speaker
Speaker
1. Touch to start (wear detection)
2. Automatically enter Bluetooth pairing mode after power-on
Function key on the left
1. Touch and tap 2 times: answer the call/end the call
2. Touch and click 2 times: next song
3. Touch and click 1: Play/pause
4. Touch and hold for 2s: voice assistant
5. Touch and click 3 times: volume is reduced
Function key on the right
1. Touch and tap 2 times: answer the call/end the call
2. Touch and click 2 times: previous song
3. Touch and click 1: Play/pause
4. Touch and hold for 2s: reject the call
5. Touch and click 3 times: volume increases
Function key on both sides
1. Long press for 5S on both sides at the same time: force
into the pairing, and give priority to the left and right mirror
legs to form a team
2. Press and hold for 8S on both sides to clear the Bluetooth
address or restore factory Settings
Indicator light
1. Switch on the blue indicator for 1S
2. Pairing mode The red and blue lights blink alternately
3. Charge the red light, full bright blue light
4. Low power indicator: < 20%. The red light blinks
5. Clear the Bluetooth address blinking red at short intervals
Power Off:
1. No touch, let the glasses stand for 15 seconds to shut down.
2. Power off automatically after charging
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:(1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on
, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without
restriction.
/
