AD-TVC Page 1 of 2
Installation Guide
AD-TVC
TV Cart
COMPONENT CHECKLIST
B
Wheel
(x4)
N
Screw
M4x35mm
(x6)
H
End Cap
(x4)
N
Screw
M5x35mm
(x6)
N
Screw
M4x16mm
(x6)
K
Screw
M4x8mm
(x2)
N
Screw
M5x16mm
(x6)
N
Screw
M6x35mm
(x6)
N
Screw
M6x16mm
(x6)
N
Screw
M8x35mm
(x6)
N
Screw
M8x16mm
(x6)
L
Screw
M8x14mm
(x12)
P
Spacer
12mm
(x6)
P
Washer
1/4”
(x6)
P
Washer
M5
(x6)
M
M8 Spring
Washer
(x6)
J
6mm
Allen
key
(x1)
A
Base
(x1)
G
Rail
(x1)
D
Upper
Column
(x2)
E
Bracket
(x2)
C
Lower
Columns
(x1)
F
Shelf
(x1)
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! The manufacturer accepts no responsibility for incorrect installation.
! Note: The maximum load to be applied to the shelf is 5Kg (11lbs)
REQUIRED TOOLS
WEIGHT RANGE
• Phillips Head Screwdriver
0 - 50kg
(0 - 110lbs)
AD-TVC Page 2 of 2
Assembly instructions
atdec.com | atdec.co.uk | atdec.com.au
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20180730
1. Attach wheels to base. 2. Attach lower columns to base using
6x M8x14 screws and spring washers..
3. Attach shelf assembly.
Note: The shelf can be installed at one
of three heights from the oor: 559mm,
772mm or 902mm.
Note: Not all displays will require the
use of spacers shown here.
Note: The installation is now complete!
B
J
L
M
F
A
J
C
L
E
P
N
J
H
L
K
D
G
E
P
N
J
H
L
K
D
G
E
P
N
J
H
L
K
D
G
E
P
N
J
H
L
K
D
G
E
P
N
J
H
L
K
D
G
B
J
L
M
F
A
J
C
L
B
J
L
M
F
A
J
C
L
4. Screw 2x upper columns to lower
columns, then secure in place with screws.
8. Fasten the screws attached to the rear
of the bracket to secure them in place.
6. Mount the display to the brackets
using the suitable screws and spacers.
7. Install the display by hooking the brackets
to the rail. Place the end caps into the top of
each column.
5. Install the rail at the desired height.
/
