ALLEN GROUP INT’L INC WF0004202 User manual

Hello! I am an AI chatbot trained to assist you with the ALLEN GROUP INT’L INC WF0004202 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

ALLEN GROUP INT’L INC

DARK GRAY CURVED CLASSICAL BENCH

MODEL # WF0004202

NOTE: The schematics in this manual are for assembly and operation illustration only. They may differ from the

bench’s actual appearance.

THANK YOU FOR YOUR PURCHASE OF THIS OUTDOOR BENCH. IF YOU ARE MISSING

ANY FASTENERS, OR NEED REPLACEMENT, PLEASE CONTACT OUR CUSTOMER

SERVICE DEPARTMENT BY ALLENGROUPINTL@GMAIL.COM OR TOLL FREE AT

1-866-321-0399, MONDAY THROUGH FRIDAY FROM 8:00AM TO 5:00PM.

ALLEN GROUP INT’L INC

377 South Lemon Ave, Suite A Walnut, CA 91789

Customer Service Toll Free 1-866-321-0399

Monday through Friday from 8:00am to 5:00pm

ASSEMBLY INSTRUCTIONS

Step 1: Remove all of the parts from the carton and carefully place them on a clean level surface. Use caution to avoid

damaging the product. Make sure no parts are missing.

Step 2: Lay the bench top down with the holes facing up.(Noted: one nut is imbedded inside each hole)

Step 3: Position the bench legs on the bench top, pay attention to have letter sticker “A, A1, B, B1” on bench top. Make

sure the bench top letters align with the same letters that are on the bench legs. The metal tabs align with the

holes.

Step 4: Place one washer on each bolt.

Step 5: Insert the bolts through the metal tab.

Step 6: Thread the bolts into the nuts and tighten by hand. Do not tighten completely.

Step 7: Check the alignments of the legs and securely tighten all bolts using the wrench (Included).The bench is

completely assembled as shown in Fig 2.

WARNING! Always use this bench on level and stable surfaces! Never use this bench on

inclined,uneven, or unstable surfaces! Improper use may result in serious injury!