Accessories
3x4.75
RLN4853
Adapter Cable
1
GENERAL
The RLN4853 Adapter Cable is a passive cable,
used to make connections to the mobile
Professional Radio when the radio is to be
programmed or flashed via the accessory port.
The adapter cable has a 20-way accessory
connector at one end, which connects to the radio,
and an 8-pin Telco connector (which will accept a
10-pin Telco plug) at the other end. Programming
cables GTF374 and RKN4081 connect to the
Telco connector.
OPERATION
Refer to the relevant procedures for the radio and
make connections to the radio as directed.
Do not disconnect the cable in the
middle of a procedure. This may
leave the radio incorrectly configured
and degrade the radio performance.
SERVICE
The Adapter Cable is not repairable. Order a
replacement cable as necessary.
!
C a u t i o n
19B05_EN Page 1 Friday, July 2, 1999 1:42 PM
2
SCHEMATIC DIAGRAM
CONNECTOR DETAIL
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Bus +
Boot Control
1
2
3
4
5
6
7
8
P1
8-way Telco
P2
20-way accessory
Switched Battery Voltage +
Ground
FLT A + (12V)
Ground
PTT
Bus +
Viewed from
Front (pin end)
of Connector
P2 (Female)
To Mobile Radio
Accessory
Connector
P1
Telco Connector
275± 5mm cable
2
7
1
20 19
13
17
18
Pin 8
Pin 1
19B05_EN Page 2 Friday, July 2, 1999 1:42 PM
6864119B05
© 1999 by Motorola, Inc.
Radio Products Group
Jays Close, Viables Industrial Estate,
Basingstoke, Hampshire RG22 4PD United Kingdom
and Motorola are registered trademarks of Motorola Inc.
Professional Radio and GP are trademarks of Motorola Inc.
All Rights Reserved.
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Motorola HLN9742 User manual
-
-
-
Motorola Malux MTM5x00 Series Installation guide
-
-
-
Nikon Radius CM300 User manual
-
-
Extreme Networks AP-6511 Installation guide
-
