Nature Power 23107 Owner's manual

Brand: Nature Power

Model: 23107

Type: Owner's manual

TERRACE SOLAR LAMP POST AND PLANTER

!"#$%&'$()"*+,"& ,- * .*Version(1.2*

Item #23107

Thank( you( very( much( for( choosing( a( Nature( Power( Product!( For( future( reference,( please(

complete(the(owner’s(record(below:(

(

((((((Model:(_______________( ( ( ( ( Purchase(Date:(_________ _ _ _ _ _ _(

(

Save(the(receipt(and(these(instructions.(It(is(important(that(you(read(the(entire(manual(to(

become(familiar(with(this(product(before(you(begin(using(it.( (

This(product(is(desig n e d (for (cer tain (a p p lica tio n s (on ly .(Th e (dis trib u to r(ca n n o t(b e (responsible( for(issues(

arising(from( m odification.(W e(strongly(recom mend(this( m achine(not( be(modified( and/or(used(for(any(

application( other( than( that( for( which( it( was( designed.( If( you( have( any( questions( relative( to( a(

particular( application,( DO( NOT( use( the( product( until( you( have( first( contacted( the( distributor( to(

determine(if(it(can(or(should(be(performed(on(the(product.(

(

For(technical(questions(please(call(/0122031102342.(

(

567689:*;9<6=>*8?:6;*

* @987!75A*

Read(carefully(and(understand(all(9;;6+B:>*97C*DE689=!D7*!7;=8?F=!D7;(before(operating.(

Failure(to(follow(the(safety(rules(and(other(basic(safety(precautions(may(result(in(serious(personal(

injury.(

(

F9?=!D7A*C)*")$*,--)G*HI%#)"#*$)*)HI%,$I*)%*,##IJK-I*$L(#*#)-,%*H)#$*-,JH*&"$(-*$LIM*

L,NI*%I,O*$L(#*J,"&,-*,"O*L,NI*OINI-)HIO*,*$L)%)&PL*&"OI%#$,"O("P*)Q*L)G*$LI*#) -,%*H)#$*-,JH (

G)%R#S*

(

@987!75A* =LI* G,%"("P#T* ',&$()"#T* ,"O* ("#$%&'$()"#* O(#'&##IO* ("* $L(#* ("#$%&'$()"*

J,"&,-* ',"")$*')NI%*,--*H)##(K-I*')"O($()"#*)%*#($&,$()"#*$L,$*')&-O* )''&%S*It(must(be(und e rs to o d (b y (

the( op erato r(that(com m on (sense(and(cautio n(are(factors,(w h ich (canno t(be(built(into(this(product,(but(

must(be(supplied(by(the(operator.(

(

;9U6*=V6;6*!7;=8?F=!D7;*

PARTS & HARDWARE LIST

PART#

DESCRIPTION

QUANTITY

Lamp Head

Metal Hanger

Upper Post

Middle Post

Lower Post

Lamp Post Base

Top Planter Base

Bottom Planter Base

Support Ring

M6 Screw

Flat Washer

M10 Nut (Hex Nut)

Acorn Nut

M10 Bolt

J-Bolts

Mounting Plate

Part Detail

Carefully remove the contents from the package. If any parts are missing do not

attempt to use the product until they have been obtained and correctly installed.

ASSEMBLY INSTRUCTIONS

Lantern Assembly

Figure 1

1. (SEE FIGURE 1) Put lantern body onto the

lamp head (A) then turn clockwise to secure.

Planter Base Assembly

Figure 2

Note: If using ground mounting instead of

Planter base mounting refer to “Ground

mounting” on page 3.

1. (SEE FIGURE 2) Attach lamp post base (F)

to Bottom planter base (H) using M10 bolts (N),

mounting plate (P), Flat washer (K) and hex Nut

(L). Make sure the mounting plate, flat washer

and hex nut are secured to the hex bolt on the

underside of the bottom of the planter base (H).

Figure 3

2. (SEE FIGURE 3) Attach the top planter base

(G) To the bottom planter base (H) by lining up

the

4 tabs and pulling the top planter base up until

Tabs snap into place. Turn the top planter base

Clockwise to lock the tabs into place.

Note: It may be necessary to put pressure on

The bottom planter base when pulling the Top

planter base up.

Support Ring Assembly

Figure 4

1. (SEE FIGURE 4) Place the support ring (I)

onto the top of the lower post (E). Attach lower

post (E) to lamp post base (F) using 1 in.

screw(J) in 3 places. Lower the support Ring

down the post until it rests on the top of

The top planter base (G). To complete the solar

Lamp post with planter go to “Lamp Post

Assembly” steps 2,3 and 4 on page 4.

CAUTION: To prevent product damage or

personal injury from tip-over, lamp post planter

base must be placed on a flat, level surface and

be filled with 4 in. (minimum of 40 lbs.) of gravel

or stone.

Damage due to improper site selection, weighting

or stabilization of the Lamp Post is not covered

by Warranty.

Alternate Ground Mounting

Figure 5

1. (SEE FIGURE 5) Thread hex nut (L) onto the

J-bolt (O). Make sure the hex nut is threaded

down the j-bolt far enough for the top of the J-bolt

to fit through the mounting plate (P) and the lamp

post base (F) with enough threads to secure the

base to the J-bolts with acorn nuts(M). Repeat

the step for other j-bolts.

2. Using the mounting plate (P) as a guide insert

the J-bolts with hex nuts into a wet concrete pad

until the hex nuts are below pad level.

3. Place the mounting plate (P) onto the J-bolts

forming a mounting bracket.

4. Align the lamp post base (F) holes with the

J-bolts and secure with the acorn nuts (M).

Note: Refer to “Lamp Post Assembly” on page 4.

Lamp Post Assembly

Figure 6

1.(SEE FIGURE 6) Attach the lower post (E) to the

lamp post base (F) using 1 in. screw (J) in 3 places.

2. Place the completed lamp head (A) through the

metal hanger (B) on the upper post (C) and twist

clockwise to secure.

Note: If using the planter base to mount the lamp

post, refer to Figure 4 before proceeding to the next

step for lamp post assembly.

3. Place the middle post (D) onto the lower post (E)

and twist clockwise to secure.

4. Place the upper post (C) onto the middle post (D)

and twist clockwise to secure.

OPERATING SOLAR LIGHT

Instructions for First Time Use

Allow Lamp Post to charge for at least 8 hours in full sunlight with the ON/OFF switch in

the OFF position. Once the batteries are fully charged, set the ON/OFF switch to the

desired setting.

Note: If the Lamp Post does not turn on after initial charging, ensure the batteries are

making contact with the terminals and the ON/OFF switch is in position ”L” or ”H”.

Where to Place the solar Light

Place the Lamp Post in an area where it will receive direct sunlight for at least 8 hours per

day. The number of hours of nighttime illumination is directly proportional to the number of

hours of sunlight it receives. If the light is placed in a shaded area, it will not be able to fully

charge and its duration of illumination will be limited. Do not place the Lamp near other

outdoor lighting like porch or street light- it may deceive the auto sensor and keep the light

from coming on, or cause it to turn off automatically.

On/Off Switch

(SEE FIGURE 7) Slide the ON/OFF selector

Switch to the desired position:

Position

Function

Comments

Figure 7

“OFF”

OFF

Initial use or

Re-charging after

battery replacement

“L”

Low

Brightness

Auto Dusk to Dawn

Operation-8 hours

Run time

“H”

High

Brightness

Auto Dusk to Dawn

operation-5 hours

Run time

CARE AND MAINTENANCE

Care Instructions:

1. Clean any dirt and debris from the solar panels. The panels cannot recharge if

obstructed. Use a soft cloth to clean the panels. Do not use abrasives or chemicals

that might scratch or damage the UV coating.

2. In a region where snow and ice are likely, the batteries are required to be charged for at

least 8 hours if the assembly is covered with snow for an extended period of time.

Battery Replacement:

Figure 8

Note: The batteries in your solar panel come

preinstalled from the factory.

1. (SEE FIGURE 8) Remove the screws from

the underside of the solar panel housing. Solar

panel housing is located on the top of the

lantern assembly.

2. Carefully lift the solar panel off the housing.

Circuit wires are attached to the solar panel,

Be careful not to disconnect the wires.

Batteries compartment is located under the

Solar panel.

3. Remove old batteries.

4. Replace old batteries with 3”AA” rechargeable Ni-Nh batteries. Reference polarity

direction inside battery compartment.

5. Replace the solar panel on the housing and Secure with screws retained from step 1.

6. The rechargeable batteries need to be fully charged before operating light assembly.

See ”Operation Solar Light” to restore solar light assembly to full operation.

Recycling

Please dispose of batteries properly.

Consult your local telephone listings for a battery recycling center in your area.

+9!7=6797F6*

+,("$,("*M)&%*#)-,%*-,JH*H)#$S*It(is(recomm e n d e d (th a t(th e (g en e ra l(c o n d itio n (o f(a n y (solar(lamp(post(

be(examined(before(it(is(used.(Clean(the(solar(module(with(a(damp(towel(to(insure(optimum(

performance(of(the(solar(post(lamp.(Do (no t(u se (an y(ty p e(o f(so lve n t(fo r(clea n ing (an d (be (ca ref ul(not(to(

put(too(much(pressure(on(the(module(while(cleaning.*

(

:!+!=6C*@98897=>*

Nature(Power(warrants(our(products(to(the(original(purchaser(that(this(product(is(free(from(defects(in(

materials(and(workmanship(for(the(period(of(one(year(from(date(of(purchase.( (

C,$IO*E%))Q*)Q*E&%'L,#I*(#*%IW&(%IOS* *

(

E-I,#I*')"$,'$*7,$&%I*E)GI%*E%)O&'$#*$)*,'W&(%I*J)%I*("Q)%J,$()"*)%*$I'L"(',-*#&HH)%$A(

1Q800Q588Q0590(

info@natu re p o w er p ro d uc ts.c o m(

www.naturepowerproducts.com(

Nature Power 23107 Owner's manual

Brand: Nature Power

Model: 23107

Type: Owner's manual

Download PDF

report

Nature Power 23107 Owner's manual

Nature Power 23107 Owner's manual

Related papers

Other documents