Grizzly T10116
The Grizzly T10116 is an auxiliary table designed to replace the spindle sanding table included with the Grizzly G0563/G0564 oscillating edge sander. This table provides improved dust collection by allowing you to connect a dust hose to it, which helps to keep your work area clean and free of sanding dust. The table is made of cast iron, which is a durable and sturdy material that will last for many years.
The T10116 comes with four different table inserts that can be used to accommodate different sized sanding drums and belts. The 4 ¼" insert is pre-installed in the table and is designed for sanding on the end of the main sanding belt. The other three inserts (3 ¼", 2 ¼", and 1 ¾") are designed for sanding on the spindle drums of the sander.
Grizzly T10116
The Grizzly T10116 is an auxiliary table designed to replace the spindle sanding table included with the Grizzly G0563/G0564 oscillating edge sander. This table provides improved dust collection by allowing you to connect a dust hose to it, which helps to keep your work area clean and free of sanding dust. The table is made of cast iron, which is a durable and sturdy material that will last for many years.
The T10116 comes with four different table inserts that can be used to accommodate different sized sanding drums and belts. The 4 ¼" insert is pre-installed in the table and is designed for sanding on the end of the main sanding belt. The other three inserts (3 ¼", 2 ¼", and 1 ¾") are designed for sanding on the spindle drums of the sander.
Grizzly T10116
The Grizzly T10116 is an auxiliary table designed to replace the spindle sanding table included with the Grizzly G0563/G0564 oscillating edge sander. This table provides improved dust collection by allowing you to connect a dust hose to it, which helps to keep your work area clean and free of sanding dust. The table is made of cast iron, which is a durable and sturdy material that will last for many years.
The T10116 comes with four different table inserts that can be used to accommodate different sized sanding drums and belts. The 4 ¼" insert is pre-installed in the table and is designed for sanding on the end of the main sanding belt. The other three inserts (3 ¼", 2 ¼", and 1 ¾") are designed for sanding on the spindle drums of the sander.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI