• Input: 5V 1A
• Output: 5V 1A / 5V 1.5V
• Capacity: 7800mAh
• Charge time: 7 - 8 hours
• Electric Leakage protection
• Recharge cycle: ≥ 600
• 2 x USB out put sockets 5V 1A / 5V 1.5V
• Power ON/OFF switch
• Display showing charge left in percentage
• Over charging and discharging protection
• Electric Leakage protection
• High conversion rate
Installation:
Switch the power off before commencing with the installation.
• Power bank charging:
• Use the included charging cable, the USB plug end into the power adapter or computer USB
port, and the other end into the power bank.
• Charging mobile phones from power bank:
• connect the corresponding output plug to the phone, then use an adapter to connect the USB
cable to the phone, and the other end of the cable to the power bank.
• Before using the mobile power to charge the device, check the cables and adapter are
connected properly.
• Recommend to use high-quality power adapter to Supplier charge the power bank, to avoid
damage to the product.
H187 - attachments:
If the external exible cable or cord of this Mobile Power Supply is damaged, it should be exclu-
sively replaced by the manufacturer or his service agent or a similar qualied person in order to
avoid a hazard.To ensure that you get maximum longevity and maximum use out of your Mobile
Power Supply, please observe the following safety instructions.
Electrical products can cause death, injury, or damage to property. Installation of the Mobile
Power Supply must be carried out by a qualied electrician, in accordance with SANS 10142.
On completion of installation, ensure that the Certicate of Compliance is updated.
• Before connecting this Mobile Power Supply, ensure that voltage indicated on the rating label
corresponds with the mains voltage in your home.
• When changing ensure that the power is turned off.
• ThisMobile Power Supply is checked in full for conformity to the quality standards and
safety requirements.
• The manufacturer / supplier is not responsible for any damage of properties and persons,
caused by the incorrect use or installation of the Mobile Power Supply.
• Should you be unsure of how to install thisMobile Power Supply correctly,
please consult a professional electrician or your supplier for assistance.
IMPORTANT:
• Tampering with this Mobile Power Supply, will invalidate your warranty.
• Please check whether the connection of the power cord is safe and reliable before installation.
• Always ensure that the mains supply voltage is correct.
• Ensure that you do not place the Mobile Power Supply near any combustible materials
and / or surfaces.
• Choking hazard: May contain small parts. Keep away from children.
• Do not insert your ngers or any part of your body into the electrical contact and sockets of this
product whilst it is connected to the electricity supply.
• Do not disassemble this product or put the battery into a re or at high temperature
that can cause an explosion.
SPECIFICATIONS
IMPORTANT SAFEGUARDS
INSTALLATION
CLEANING
• Before cleaning always ensure the power supply is turned off.
• Do not immerse the Mobile Power Supply in water.
• No abrasive products, solvents, detergent may be used to clean this Mobile Power Supply.
• Ensure that the product does not come in contact with corrosive chemicals, etc.
• Coastal areas ensure that the Mobile Power Supply is cleaned fortnightly.
• Do not leave it near ammable materials.
• Do not put it in the sun exposure.
• Do not collide it with hard objects.
• Completely charge it when the % is low
• Item may vary slightly from the picture on the carton.
1
2
Magtek Payment Applications Services Operating instructions
ALGE-Timing PS-KP Battery power supply User guide
Sencor SSS 6700 User manual
Sencor SSS 6701 User manual
Gateway ID47H User manual
