JET 1/2-PT Owner's manual

Hello! I've reviewed the JET Plain Trolley Installation and Safety Instructions. This document provides crucial guidelines for the proper installation and safe use of your trolley, including instructions on beam compatibility, weight limits, and adjustment methods. I'm ready to answer any questions you may have about your Plain Trolley.
What type of beams are JET Plain Trolleys designed to be used on?

What is the minimum wheel to flange clearance for installation?

Is it important to use the trolley with a hoist of the same capacity?

How should the washer spacers be moved when the trolley width is extended?

JET Plain Trolley Installation and Safety Instructions

Specifications:

Model No. Stock No. Capacity Minimum Beam Flange Width Beam Height

Radius Curve (min. - max.) (min. - max.)

1/2-PT 252005 1/2 Ton 39” 2-1/2" - 8" 4” - 19"

1-PT 252010 1 Ton 39” 3" - 8" 4” - 19"

1-1/2-PT 252015 1-1/2 Ton 43” 3-1/4" - 8" 4” - 19"

2-PT 252020 2 Ton 43” 3-1/4” - 8" 4” - 19"

3-PT 252030 3 Ton 51” 4" - 8" 5” - 19”

5-PT 252050 5 Ton 55” 4-5/8" - 8" 5” - 19”

10-PT 252060 10 Ton 67” 4-3/4" - 8" 5” - 19”

JET Plain Trolleys are designed to be used on either "Ι" or “H” wide flange beams.

WARNING

1. Beam must be properly installed and rated for anticipated loads.

2. Do not install trolley on beams of unknown capacity.

3. Do not install trolley on damaged or deformed beams.

4. JET trolleys are designed to be used with hoists of the same rated capacity. Never use a hoist with a

capacity greater than the capacity of the trolley.

5. Never subject trolley to a side pull or load. Load must be centered directly under the hoist / trolley assembly.

6. Make sure load is stable and secure before moving.

7. Never lift load more than is necessary to safely move it.

8. Always follow installation instructions.

9. Do not use if under the influence of drugs, alcohol, or medication.

Installation Instructions

Note: For installation clarity,

drawing does not show

side plate flanges.

1. Trolley must be installed on a beam with a minimum clearance (wheels to flange) of 1/16" to a maximum of

1/8". Reference "A" on both sides of the beam.

2. To extend trolley width, remove washer spacers from center bolt and place between hanger bracket "C" and

fixed spacer "D". Note: Washer spacers must be moved in sets of two, one on either side of the hanger

bracket, as the hanger bracket must always remain centered between the trolley side plates.

3. Once trolley is spaced properly, install remaining washer spacers on the center bolt (same number on both

sides) on the outside of the side plates. Install nuts and split pins "B". Do not over tighten nuts. Tighten

nuts and then back nuts off to align the nut with hole in shaft for split pin. Insert split pin through both nuts

and bend one end of split pin.

4. Re-check wheel clearance "A" and re-adjust if necessary.

NO. M-252005 8/00

JET EQUIPMENT & TOOLS, INC. P.O. BOX 1349 Phone:253-351-6000

A WMH Company Auburn, WA 98071-1349 Fax: 1-800-274-6840