IMPORTANT SAFETY INFORMATION
Please read all instructions before installing this equipment.
Pay attention to all safety warnings and any other special
notes in the manual. Safety markings are used frequently
throughout this manual to designate a degree or level
of seriousness and should not be ignored.WARNING
indicates a potentially hazardous situation that if not
avoided, could result in personal injury or death.
These instructions are primarily intended to assist qualified
individuals experienced in the proper installation of this
kit. Some local codes require licensed installation/service
personnel to install this type of equipment. Please read
all instructions carefully before starting the installation.
Return these instructions to the customer’s package for
future reference.
WARNING:
RISK OF ELECTRICAL SHOCK
Shut off all electrical power to the unit before
performing any maintenance or service on
the system. Failure to follow this warning can
cause serious injury, fire, electrical shock, or
death.
INSTALLATION INFORMATION
1. Turn OFF all electrical power to the unit.
2. Evacuate any refrigerant from the coil and properly
reclaim it.
3. Remove the top panel, the bottom front panel, and the
access panel from the unit. NOTE: This will allow the
coil and tubing to be removed.
4. Remove coil from system.
5. Locate the two side rails in the replacement kit.
• Therailsareinstalledasshown,usingtheexisting
holes in the cabinet. See Figure 1.
• Makesuretheareaontherailthatsitsushwiththe
side of the cabinet is not visible from the front.
6. Install the coil by inserting the tabs (on the sides of the
coil) into the notches of the side rails and then raising
it upwards against the side rails. See Figure 2.
7. Install the top bracket over the side rails and coil frame.
See Figure 3. NOTE: Align the holes in the top bracket,
side rails and coil brackets and secure with one screw
(each side). The screw will hold the front bracket, rail,
and coil together.
8. After the coil is installed, refer to the Startup & Adjustment
section in the installation instructions supplied with the
unit. Follow all instructions regarding how to correctly
charge and start it up the unit.
INSTALLATION INSTRUCTIONS
COIL REPLACEMENT FOR B6BW & B6EW AIR HANDLERS
Figure 1. Side Rail Installation
INSTALL BOTH SIDE
RAILS USING
THE EXISTING
HOLES IN THE CABINET
(BOTH SIDES)
BACK SIDE
OF COIL
INSTALL TAB IN THE
SIDE RAIL NOTCH
(BOTH SIDES)
RAISE COIL UPWARDS
AND ALIGN HOLES
(BOTH SIDES)
1
2
Figure 2. Coil Installation
7097150 (NEW)
DRAIN PA N
TOP BRACKET
LEFT SIDE RAIL
COIL
Figure 3. Top Bracket and Coil Installation
Specifications & illustrations subject to change without notice or incurring obligations (05/15).
O’Fallon,MO,©NortekGlobalHVACLLC2015.AllRightsReserved.
-
1
-
2
Kelvinator Coil Replacement for B6BW & B6EW Air Handlers Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
McQuay Vision CA Series Installation and Maintenance Manual
-
Trane Climate Changer M Series Installation Operation & Maintenance
-
True GDT Series Technical & Service Manual
-
-
International comfort products FSM4P3000AL Installation guide
-
Allied BCE5C Installation guide
-
McQuay Skyline OAH 035G Installation and Maintenance Manual
-
Lennox CBX27UH Installation Instructions Manual
-
Emerson XDF User manual
-