Brief instructions
1
2 4
68
3
7
5
1. On/off button
2. Program button
3. Programme indicators
4. Display
5. Delay button
6. Start button
7. Indicators
8. Option button
Programme Degree of soil, type of load
• Normal soil
• Crockery and cutlery
• All
• Crockery, cutlery, pots and pans
• Heavy soil
• Crockery, cutlery, pots and pans
• Normal or light soil
• Delicate crockery and glassware
• Fresh soil
• Crockery and cutlery
• All
Indicators Description
Washing phase. It comes on when the washing
phase and the rinsing phases operate.
Rinsing phase. It comes on when the rinsing phase operates.
Drying phase. It comes on when the drying phase operates.
End indicator.
TimeSaver indicator.
XtraDry indicator.
Rinse aid indicator. It is always off while the programme operates.
Salt indicator. It is always off while the programme operates.
Delay indicator.
XtraHygiene indicator.
EN
OPTIONS OPERATING THE APPLIANCE
Starting programme Starting programme with Delay Start
1. Press On/off.
2. Press Program until indicator of the
pogramme you want to select comes on.
3. Set an option if desired.
4. Press Start.
1. Set a programme.
2. Press Delay to set duration of delay.
3. Press Start to start countdown.
When the countdown is completed,
the programme starts.
Cancelling programme Cancelling Delay Start countdown
Press Delay + Start until the appliance
is in programme selection mode.
Make sure that there is detergent in the detergent
container before starting new programme.
Press Delay + Start until the appliance is in
programme selection mode. The countdown stops.
End of the programme Opening door during operation
1. Press On/off or wait 5 minutes for Auto Off function
to automatically deactivate the appliance.
2. Close the water tap.
• When you open the door, the running programme
stops.
• When you close the door, the appliance continues
from the point of interruption.
• If the door stays open for longer than 30 seconds
during the drying phase, the running programme
is cancelled.
How to save MyFavourite
programme
Press and hold simultaneously Program and
Delay until the indicators of the programme
and the options ash for a few seconds.
How to set MyFavourite
programme
Press and hold Program until the indicators
that are related to the MyFavourite
programme and options come on.
How to activate TimeSaver
Press Option until comes on.
How to activate XtraHygiene
Press Option until comes on.
How to activate XtraDry
Press Option until comes on.
DAILY USE CARE AND CLEANING
Cleaning lters
An incorrect position of the lters
may cause bad washing results
and damage to the appliance.
Cleaning spray arms
Do not remove spray arms.
If the spray arms are clogged
after cleaning, remove the soil
with a thin pointed object.
Internal cleaning
During cleaning, clean the
rubber gasket of the door.
Run long duration programmes
at least 2 times a month.
Use a specic cleaning product
for dishwasher every month.
External cleaning
Clean the appliance with a moist, soft
cloth. Do not use abrasive products,
abrasive cleaning pads or solvents.
1.
4.
2.
5.
3.
6.
1. Press the button. (A)
2. Insert detergent or tablet into
the compartment. (B)
3. If you want to choose a programme
with prewash phase, put a small
quantity of detergent on the inner
part of the appliance door.
4. Close the lid.
Filling rinse aid container Setting rinse aid level
Fill the rinse aid container before rst use and when the indicator is clear. (C)
1. Open the lid. (E)
2. Fill the container until marking
reaches MAX. (D)
3. Remove spilled rinse aid.
4. Close the lid.
1. Press Delay + Start until
3 indicators come on.
2. Press Delay until only
stays on.
3. Press Delay to set proper
rinse aid level.
4. Press On/off.
Level 0, no rinse aid.
Level 6, maximum amount of rinse aid.
Using the detergent
Do not ll the detergent
container during rst use.
AB
CD
E
SAFETY INFORMATION TROUBLESHOOTING
Error codes
The appliance does
not ll with water.
• Make sure that the water tap is open.
• Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the lter in the
inlet hose is not clogged.
• Make sure that the inlet hose
has no kinks or bends.
The appliance does
not drain the water.
• Make sure that the sink spigot is not clogged.
• Make sure that the lter in the
outlet hose is not clogged.
• Make sure that the interior lter
system is not clogged.
• Make sure that the drain hose
has no kinks or bends.
The anti-ood
device is on.
• Close the water tap and contact
an Authorised Service.
Water connection
Make sure not to cause damage to the water hoses.
• Before you connect the appliance to new pipes or pipes not used for a long
time, let the water ow until it is clean.
• The rst time you use the appliance, make sure that there is no leakage.
• The water inlet hose has a safety valve and a sheath with an inner mains
cable.
• Without electrical power, the water protection system is not active.
In this case there is a risk of ooding.
WARNING! Dangerous voltage.
If the water inlet hose is damaged, immediately close the water
tap and disconnect the mains plug from the mains socket. Contact
the Authorised Service Centre to replace the water inlet hose.
117883910-A-442016
-
1
-
2
-
3
-
4
Electrolux GA60LICN Quick start guide
- Type
- Quick start guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Electrolux GA60SLISSP User manual
-
-
-
-
-
-
Electrolux GA55IEEVCN User manual
-
-
-