These instructions will detail how to assemble one (1) of the ve (5) sections that make up the frame of the Bazoongi JumpPod.
Once you have assembled one section of the frame, you can simply repeat this process to complete additional sections.
When all ve sections are complete, connect them together to complete the trampoline.
These instructions may differ from the instruction book, but this method tends to allow for easier assembly.
Additionally, this method makes it easier for one person to put together the trampoline by themselves.
We recommend to have an additional person to help with assembly.
Version 10112007
Bazoongi JumpPod (BZJP1506)
Trampoline Section Instructions.
Here is one (1) of ve (5) sections of the JumpPod.
Note: The one leg extension is already inserted into the “w” leg section and the other leg extension
is already inserted into the “pod-connector”.
Your top tubes should have “A” and “B” markings.
The A and B markings on your top tubes will correspond to this picture.
Let’s begin by looking at the rst tube. (far left)
A
A
A
B
B
“Leg Extension”
“Leg Extension”
“W-Leg Base”
“Pod Connector”
2
Note: The “bottom” has two (2) holes.
The side that goes into the POD connector
(as pictured, above “larger”) is larger than the
small swedge on the right (enlarged picture).
larger
smaller
3
“Underside”
“Underside”
“Top of Tube”
“Swedge”
Note: Top has four (4) holes, one
(1) on the “swedge”
4
Moving on to the next tube...
This tube should come with the support socket attached.
It has two (2) holes on the “underside” and four (4) holes on the “top” side.
Note: It does NOT have any spring holes on the “swedges”.
“Swedge”
“Underside”
“Top”
5
Now on to the nal section...
Here we have already attached one leg
extension to the “w” leg-base.
This nal tube has both a “T-Connector” and a “Pod-Connector” attached to it.
We’ve also already attached the other leg extension to the “Pod-Connector”.
“T-Connector”
“Pod-Connector”
Note that this side of the top
tube has only two (2) holes.
6
Attach all the pieces together like this and you have now completed one (1) of ve (5) sections of the trampoline.
Repeat the process to make the four (4) other sections just like this one.
7
When all the legs are complete, arrange them on the ground in a circle with the legs facing upwards.
8
Diagram 1
Diagram 1: Now take two sections of completed legs and ip them over and rotate them 180º.
Diagram 2: Next, connect these two sets of legs together at the T-connector of one and the open tube of the other.
Diagram 5 : Finally, ip over, rotate, and connect the nal
leg set to complete the ring of the trampoline frame.
Diagram 5
Diagram 2
Diagram 3 Diagram 4
Diagram 3 & Diagram 4: Now, ip over, rotate, and connect the next three leg sets to the complete previous sets.
9
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
Jumpking BZJP1506 Assembly Instructions
- Type
- Assembly Instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Bazoongi BZJP1206 Assembly Instructions
-
Bazoongi BZJP1406 Assembly Instructions
-
Jumpking JP1414C Owner's manual
-
-
-
-
-
-
-
