Nashua Tape 1207794 Installation guide

Brand: Nashua Tape

Model: 1207794

Type: Installation guide

Feb. 2009

The information presented herein was prepared at BERRY GLOBAL, INC. (25 Forge Parkway Franklin, MA 02038) by quali ed technical personnel. To BERRY’s’ knowledge it is true and accurate. However, the infor-

mation and recommendations are furnished for these products with the understanding that the purchaser or user, as the case may be, will independently determine that the product is suitable for the intended use, and

that such use complies with all applicable federal, state and local laws and regulations. The data are submitted only for the user’s information and consideration, and do not constitute a warranty of any kind (including

but not limited to a warranty of merchantability or of  tness for a particular purpose), or a representation for which BERRY assumes any legal responsibility.

INSTALLATION GUIDE - FLEXIBLE DUCT

Connections

Splices

ADC Flexible Duct Performance & Installation Standards Fifth Edition 4.7.1

Installation Instructions for Air Ducts and Air Connectors - Nonmetallic with Plain Ends

Step 1: : After desired length is determined, cut completely

around and through duct with knife or scissors. Cut wire

with wire cutters. Fold back jacket and insulation

Step 2: Slide at least 1” [25 mm] of core over tting and

past the bead. Seal core to collar with at least 2 wraps of

duct tape. Secure connection with clamp placed over the

core and tape and past the bead.