Troy-Bilt 12AGA26E011 Fast Start Guide

Troy-Bilt
Brand
Troy-Bilt
Model
12AGA26E011
Type
Fast Start Guide

This manual is also suitable for

Hold blade control handle against upper handle. A.
Slowly pull starter rope handle from engine and B.
slip starter rope into the rope guide.
Tighten rope guide wing knob.C.
Use cable tie to secure cables to lower handle.D.
Form No. 778-12230© 2011 12AGA26
Note: Refer to your Operator’s Manual
for instructions on attaching the grass collector.
Remove the wing nuts and carriage bolts A.
securing the upper handle to the lower
handle.
A
Pivot the upper handle
upward.
Note: Refer to your Operator’s Manual
for instructions on attaching the grass collector.
Insert the T-bolts removed in Step 1B A.
through the handle brackets to secure
the handle in place.
A
B
C
D
Starter
Rope Handle
Blade Control Handle
Wing Nuts
Ignition
Switch
Remove T-bolts from B.
the handle brackets.
Pull upward on the
handle until the holes
in lower handle line
up with the holes in
the handle bracket.
A
B
B
T-Bolt
Battery
Secure upper handle B.
to lower handle with
wing nuts (on outside)
and carriage bolts
removed Step 1A.
A
B
1
4
2
5
3
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Form No. 778-12230© 2011 12AGA26
Fill fuel tank with clean, fresh gasoline. Do not
fill above the base of fuel tank neck.
Pour the entire contents of the oil bottle (supplied)
into the oil fill. Check the oil level using the
dipstick. (Refer to the Operator’s Manual)
While standing behind the machine, pivot the Blade A.
Control Handle against the upper handle.
Turn the ignition key clockwise to start the B.
engine. If the engine does not start after repeated
attempts, wait a few minutes and repeat.
Oil Fill /
Dipstick
Gas Fill
Primer
3
Push the primer three times.
A
A
B
B
Plug the battery charger into the port on the side A.
of the battery housing.
Insert the battery charger plug into a standard 120 B.
volt outlet. Charge battery for eight to 10 hours.
Do not charge longer than 12 hours.
6
9
7
10
8
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
  • Page 1 1
  • Page 2 2

Troy-Bilt 12AGA26E011 Fast Start Guide

Troy-Bilt
Brand
Troy-Bilt
Model
12AGA26E011
Type
Fast Start Guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents