Kichler Lighting 52119BK User manual

Brand
Kichler Lighting
Model
52119BK
Type
User manual
IS-52119-US
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
I
G
O
J
D
B
C
M
H
F
E
►
►
N
K
L
►
A
P
C
N
M
A
STEM HUNG MOUNTING INSTRUCTIONS
1) NOTE: At least one (1) 6 inch tube must be used during mounng. Pass xture
wire from the coupling on top of xture through a stem [B] and threaded
tubes [C] and screw stem into coupling [A] on top of the main body.
NOTE: Thread locking compound must be applied to all stem threads as
noted with symbol (4) to prevent accidental rotaon of xture during
cleaning, relamping, etc.
2) Pass xture wire through desired amount of stems and screw stems together
using supplied short threaded tubes.
3) Pass xture wire from last stem through rst loop [D]. Thread rst loop onto
end of last stem.
4) Pass xture wire through second loop [E] and through hole in canopy.
5) (If second loop is already aached to canopy, proceed to next step). Pass
threaded pipe at end of second loop through hole in canopy. Thread
lockwasher [N] onto threaded pipe protruding from inside canopy. Pass
xture wire through hole in hexnut [M] and thread hexnut onto end of
threaded pipe.
6) Aach chain link [F] to small loop at end of stem and to loop on canopy. Close
the open chain link by placing a piece of cloth over the open link and using a pair
of pliers gently squeeze the link closed.
7) Find the appropriate threaded holes on mounng strap [G]. Assemble
mounng screws [H] into threaded holes.
8) Aach mounng strap to outlet box [I] using the strap mounng screws [O].
The mounng strap can be adjusted to suit posion of xture.
9) Grounding instrucons: (See Illus. a or b).
a) On xtures where mounng strap is provided with a hole and two raised
dimples, wrap ground wire from outlet box around green ground screw,
and thread into hole.
b) On xtures where a cupped washer is provided,aach ground wire from
outlet box under cupped washer and green ground screw, then thread
into mounng strap.
If xture is provided with ground wire, connect xture ground wire to outlet
box ground wire with wire connector aer following the above steps. Never
connect ground wire to black or white power supply wires.
10) Make wire connecon. Reference chart below for correct connecons and
wire accordingly.
Connect Black or Red
Supply Wire to:
Connect White Supply
Wire to:
Black White
*Parallel cord (round &
smooth)
*Parallel cord (square &
ridged)
Clear, Brown, Gold or
Black without Tracer
Clear, Brown, Gold or Black
with Tracer
Insulated wire (other
than green) with copper
conductor
Insulated wire (other
than green) with silver
conductor
*Note: When parallel wire (SPT
1 & SPT 2) are used. The neutral
wire is square shaped or ridged
and the other wire will be round
in shape or smooth
(see illus.)
Neutral Wire
11) Push xture to ceiling, carefully passing mounng screws through holes in
canopy [J]. NOTE: Be certain wires do not get pinched between canopy and
ceiling.
12) Use knobs [K] and lockwashers [L] to secure canopy. Tighten to secure.
13) Install the recommended bulbs. (Not supplied).
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
a
b
Fixture Diagram
Parts List
Cauons
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main fusebox before
starng and during the installaon.
WARNING:
This xture is intended for installaon in accordance with the Naonal Electrical
Code (NEC) and all local code specicaons. If you are not familiar with code
requirements, installaon by a cered electrician is recommended.
[A] Coupling
[B] Stem
[C] Short Threaded
Tubes
[D] First Loop
[E] Second Loop
[F] Chain Link
[G] Mounting Strap
[H] Mounting Screws
[I] Outlet Box
[J] Canopy
[K] Knobs
[L] Lockwashers
[M] Hexnut
[N] Lockwasher
[O] Strap Mounting
Screws
[P] 3 Inch Stem
Installaon Instrucons
SEMI-FLUSH MOUNTING INSTRUCTIONS
1) Pass xture wire from the coupling [A] on top of xture through the 3 inch
stem [P] and threaded tube [C] and screw stem into coupling on top of the
main body.
2) Pass threaded pipe at end of 3 inch stem through hole in canopy. Thread
lockwasher [N] onto threaded pipe protruding from inside canopy. Pass
xture wire through hole in hexnut and thread hexnut [M] onto end of
threaded pipe.
3) Follow steps 7 thru 13 from “STEM HUNG MOUNTING INSTRUCTIONS” to
complete installaon.
STEM HUNG MOUNTING
SEMI-FLUSH MOUNTING
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3

Kichler Lighting 52119BK User manual

Brand
Kichler Lighting
Model
52119BK
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents