LightOWL® Dual Technology Passive Infrared
and Acoustic Sensors (LODIA)
INSTALLATION INSTRUCTIONS
Page 1 of 8
Rev 04/11/23
WWD2-4IW_InstallSheet
currentlighting.com
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
WWD2-4IW
Installation Guide
Product Overview
The WWD2-4IW wireless dimmer is a batery powered
in-wall mount switch for use in zonal room control
or as par of a large wireless networked system. The
WWD2-4IW device installs into an existing junction
box to replace an existing switch providing a wireless
solution that enables dimming and ON/OFF com-
mands to be delivered to luminaires in its commis-
sioned space. The communication with the luminaires
or wireless controllers utilizes a secure a reliable wire-
less connection which helps minimize installation cost
and complexity.
¥ When replacing a line voltage switch, the
power must be off at the branch circuit
breaker. Bypass the line voltage switch to
provide uninterrupted power to the fixtures
and make sure the connection is properly
insulated before installing the wireless switch.
Electrical Requirements
