2. Fuller
  3. ST200

Fuller ST200 Operating instructions

  • I have reviewed the user manual for the Stud Finder ST200. This device helps locate studs behind walls using LED indicators and an audible beep. It operates on a 9V battery. I'm ready to assist you with any questions you might have about using this stud finder.
  • What kind of battery does the device require?
    How do I install the battery?
    How do I find a stud?
731949 | ST200 - STUD FINDER
ON/OFF
Instructions
POWER SUPPLY
The tools require one 9 volt battery to operate.
BATTERY INSTALLATION
1. Squeeze sides of unit to help release clip end.
2. Slide 9V battery into compartment, terminal
side first, matching (+) and (-
) terminals from
battery to case.
3. Replace the clip. Battery life is approximately
50 hours.
Using the detector
1. Position the unit flat against the wall.
2. Press on/off button and hold in.
3. Slowly slide unit horizontally across the wall, right or left. As you begin to approach a stud, the
Yellow LEDs will light, from bottom to top.
4. When the top Red LED is light and the beep sound, you have located the edge of the stud.
Mark this spot.
5. Continue scanning beyond the marked spot until the yellow LEDs go out. Slide unit in reverse
direction to locate other edge of stud.
6. Mark this second spot. Between the two spots is the stud position.
/