2. Computers & electronics
  3. Computer cables
  4. Audio cables
  5. Epson
  6. TM-L90 Plus-i KDS Liner-free Compatible
TM-L90 Plus-i KDS Liner-free Compatible

Epson TM-L90 Plus-i KDS Liner-free Compatible, TM-T88V-i KDS with VGA or COM, TM-U220-i KDS with VGA or COM User manual

  • Hello! I am an AI chatbot trained to assist you with the Epson TM-L90 Plus-i KDS Liner-free Compatible User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
111-38-QUM-004
Rev 2.30
Sound Devices
About this Guide
This guide consists of two sections:
• Overview – A brief description of what Sound Devices are.
• How-to Configure Sound Devices – A procedure that can be followed to
configure this in a Single-Station KDS Setup. This guide assumes that you
already have a Single-Station KDS system setup as described in the Epson KDS
Single-Station Quick Start Guide.
This guide is relevant for:
KDS FW: v2.30 and above
KDS Utility (Windows): v2.3.1.0 and above
Overview
USB speakers or USB->3.5mm audio adapters can be plugged directly into a KDS
Printer or controller box to allow for sound notifications on new orders. Sounds are pre-
installed onto the KDS Configuration Utility and are selectable per display.
Figure 0.1 – Example of Supported Speaker and USB->3.5mm adapter
Sound Devices
Quick User Manual
111-38-QUM-004
Rev 2.30
How to Configure Sound Devices
This procedure assumes that you already have a Single-Station KDS system setup as
described in the Epson KDS Single-Station Quick Start Guide. However this procedure
can be followed to configure a sound device for any KDS device.
1. Connect your speaker into the USB port of the printer.
Figure 1.1 – USB-A Audio Cable Connection
Figure 1.2 – 3.5mm Audio Cable Connection
2. In the KDS Utility, select the Devices configuration.
3. Select the Device that has the USB speaker/adapter connected.
Figure 1.3 – Select KDS device for audio
Sound Devices
Quick User Manual
111-38-QUM-004
Rev 2.30
4. Go to the “Sound on New Order” section.
5. Select “Choose Sound” and click “Play Sound”. This allows the user to preview
the selected sound on the PC if it has sound capability.
Figure 1.5 – Sound Selection
6. Click “Apply KDS Settings” at the top of the Utility
Figure 1.6 – Apply KDS Settings
7. The desired sound will be played on any incoming order.
/