Cannondale Super X Owner's manual

Type
Owner's manual
Page 1 of 4
BRAKE HOUSING
(install on straddle/ stirrup cable)
BRAKE HOUSING
(install on straddle/ stirrup cable)
MAIN BRAKE CABLE
STRADDLE/STIRRUP
CABLE CARRIER
BRAKE ARM
BRAKE ARM
129264 - 08/12
Page 1 of 1
TECH NOTE
08/12
Super X Cantilever Brake Housing Placement Instructions
ATTENTION MECHANIC:
It is necessary to install sections of brake housing on the straddle brake cable of both the front and rear cantilever
brakes. The installed housing sections will prevent the stirrup cable from contacting the tire in the event of failure of
the main brake cable the wheel in the event of a brake cable failure.
Please install brake cable housing lengths of the lengths indicated in the table below during set-up of the brakes. A
front brake is shown above. The same must be done for the rear brakes. The housing on each side must be fitted so the
housing covers the complete cable between the straddle cable carrier and the anchor bolts of each brake arm.
BIKE SIZE FRONT BRAKE HOUSING LENGTH REAR BRAKE HOUSING LENGTH
44 - 48 cm 110 mm 90 mm
52 - 58 cm 110 mm 110 mm
If you have questions about these instructions, please contact
CSG Technical Support at 1-800-THE-BIKE (1-800-843-2453).
  • Page 1 1

Cannondale Super X Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI