PARTS INCLUDED:
Item# 7668 - How To Assemble Your Chaise Lounge
Connect Legs with one
Front Beam using 2 Medium
Machine Threads (8 x 60 m/m).
Then use 2 Short Machine
Threads (8 x 45 m/m) to attach
Back Beam to Legs.
TOOLS NEEDED: Philips screwdriver, power drill optional
CAUTION: When assembling chair, DO NOT completely tighten the bolts and nuts until all the parts &
holes are properly aligned.
(REV. 03/2017)
Back Legs
C
C
C
G
F
Front
Legs
D
D
Step 1:
Step 2:
ITEM# 7668 - PG1 OF 2
Backrest
A
Seat
B
2 PC
Front Beams
E1
E1
E1
1 PC
Back Beam
E2
E2
E1
E2
Pitman
F
Supporting Pole
G
2 PC
Nuts
2 PC
Iron
Washer Spanner (4 x 4m/m) 13# Spanner
2 PC Long Machine Thread
(8 x 90 m/m)
14 PC Medium Machine Thread
(8 x 60 m/m)
4 PC Short Machine Thread
(8 x 45 m/m)
Right
Left
Left
Right
Step 3:
Attach Supporting Poles to Pitman.
E1
D
D
G
G
F
C
C
1 PC Short
MachineThread
(8 x 45 m/m)
1 PC Medium
MachineThread
(8 x 60 m/m)
2 PC Medium
MachineThread
(8 x 60 m/m)
Take second piece of Front
Beam and screw Front Legs
with 2 Medium Machine Threads
(8 x 60m/m).
Step 4:
Step 5:
Step 6:
Place Seat on its side and
screw Front Legs (from
Step 2) in the front of Seat
with 4 Medium Machine Threads
(8 x 60 m/m) / 2 screws for each
side.
Make sure to place the Iron
Washer & Nuts on the inside
of Back Legs.
ITEM# 7668 - PG 2 OF 2
Right
Left
Next place Seat in the middle
& screw Legs with 6 Medium
Machine Threads (8 x 60 m/m) to
Seat / 3 screws for each side.
Attach Backrest by
screwing 2 Long Machine
Thread (8 x 90 m/m), 2 Iron
Washers & 2 Nuts through
Back Legs.
B
D
A
G
G
C
C
A
B
C
C
Attach Supporting Pole
(from Step 3) to Backrest
with 2 Short Machine Thread
(8 x 45 m/m).
D
B
B
B
B
A
C
C
G
A
C
3 PC Medium
Machine Thread
(8 x 60 m/m)
1 PC Long
Machine Thread
(8 x 90 m/m), 1 Iron
Washer & 1 Nut
1 PC Short
Machine Thread
(8 x 45 m/m)
1 PC Short
Machine Thread
(8 x 45 m/m)
2 PC Medium
Machine Thread
(8 x 60 m/m)
/
