LARSON L91032439 Installation guide

L91032439
LARSON
Brand
LARSON
Model
L91032439
Type
Installation guide

This manual is also suitable for

©2014 202220845 2.14
SecurePro Security Screen
INSTALLATION GUIDE
1. Slide the expander onto the bottom of the window unit
(Figure 1). (The emergency release feature is located
on the lower sash).
2. Position the screen over the opening to check for a
proper fit.
3.
Predrill using a 1/8" drill bit, and temporarily secure
the top corners of the screen with two Phillips head
installation screws (Figure 2).
4. Adjust the expander so that it makes even contact
across the bottom of the existing window sill.
5. Predrill and install the remaining Phillips head
installation screws.
6. Ensure that the screen panel has clearance to swing
out freely by operating the emergency release feature.
7. Remove one Phillips head screw from each corner and
replace with one-way slotted security screws, using a
flathead screwdriver (Figure 3).
8. To improve weather protection, caulk the head and
jamb mounting flanges. To allow for proper drainage,
do NOT caulk the sill (Figure 4).
FIGURE 1: Sill/Expander Detail
FIGURE 2: Actual Size FIGURE 4: Caulk DetailFIGURE 3: Actual Size
RECOMMENDED INSTALLATION
EXPANDER
WINDOW SILL
EMERGENCY
RELEASE LATCH
SECURITY
SCREEN
CAULK ALONG
EDGES OF
JAMB AND HEAD
BRICKMOLD
JAMB
GLASS INSERT
SECURITY SCREEN
MOUNTING
FLANGE
INSIDE VIEW
OUTSIDE
VIEW
OUTSIDE VIEW
#8x1-1/2" PHILLIPS PAN HEAD
INSTALLATION SCREW
#8x1-1/2" ONE-WAY SLOTTED
SECURITY SCREW
  • Page 1 1

LARSON L91032439 Installation guide

L91032439
LARSON
Brand
LARSON
Model
L91032439
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents