PAC FMK550 User manual

CUSTOMER HELP LINE

USA 800-323-4329 • Canada 800-245-8777

FMK550 Mounting Kit

Ford

1995-10 CROWN VICTORIA

1997-08 ECONOLINE VAN

(Club Wagon)

2001-07 ESCAPE

2000-05 EXCURSION

1998-06 EXPEDITION

(Non Navigation)

1995-05 EXPLORER

2000-06 EXPLORER Sport Trac

1999-04 F-SERIES TRUCKS

2004 F-150

(Heritage Only)

2001-04 MUSTANG

1995-11 RANGER

1999-03 WINDSTAR

Ford Commercial Vehicles

1999-08 E-150

1997-08 E-250

1999-08 E-350

1999-08 E-450

2002-04 F-250

2002-04 F-350

2002-04 F-450

VEHICLE APPLICATIONS

Ford Commercial Vehicles Cont.

2002-04 F-550

2002-07 F-650

2003-04 F-750

Lincoln

2003-05 AVIATOR

2001-02 BLACKWOOD

1995-97 CONTINENTAL

1995-98 MARK VIII

1999-06 NAVIGATOR

1995-02 TOWN CAR

Mazda

1995-10 B-SERIES P/Uʼs

Mercury

2001-02 COUGAR (flat face radios only)

1995-10 GRAND MARQUIS

1997-05 MOUNTAINEER

2003-04 MARAUDER

2005-07 MARINER

iFMK550

TECH Ver. 11/14 PRINT Ver. 01/15

WWW.AIUS.NET

2500 East Francis Street Ontario, CA 91761, U.S.A.

USA Sales (800) 336-6500

Canada Sales (888) 922-3006

For information about other American International automotive

accessories visit our website at:

http://www.aius.net

FORD Page

1995-10 Crown Vic * 3

997-08 Econoline Van (Club Wagon) * 6

001-07 Escape * 7

2000-05 Excursion * 6

998-02 Expedition * (Non Navigation) 7

2003-06 Expedition (Non Navigation) 5

1995-01 Explorer (All) * 8

2002-05 Explorer 4

999-03 F-Series Trucks (All) * 6

004 F-150 Heritage model only * 6

001-04 Mustang 4

1995-11 Ranger * 6

1999-03 Windstar * 6

LINCOLN Page

2003-06 Aviator 9

995-97 Continental * 3

995-98 Mark VIII * 3

1999-03 Navigator * 7

995-02 Town Car * 3

MAZDA

1995-10 B-Series P/U * 6

MERCURY

001-02 Cougar * 8

1995-10 Grand Marquis * 3

2003-05 Marauder * 3

2005-07 Mariner * 7

1997-01 Mountaineer * 8

2002-05 Mountaineer 4

THIS KIT CONTAINS

MAIN BRACKET

ISO TRIM RING

ISO MOUNTING

BRACKETS

REAR

SUPPORT

SPACER NUBS

TABLE OF CONTENTS

NOTES

Due to variances on Ford, Lincoln,

Mercury and Mazda radio openings,

this installation kit has been uniquely

designed with spacer nubs. These

spacer nubs take up the play

between the installation kit and

mounting locations for a tighter fit.

Spacer nubs may have to be filed

down or cut off to allow locking tabs

to fully engage on some vehicles.

(i.e. Ford Ranger)

* These vehicles require Ford radio removal tools to remove

factory radio. American International part #URT-460

NOTES:

1 10

MOUNTING SPACERS

Optional: ISO trim ring may be used

in place of after-market radio’s trim ring.

ISO Trim Ring

(Use Optio

nal)

ISO MOUNT ASSEMBLY INSTRUCTIONS

1. Attach left and right mounting brackets to rear of kit as shown in Fig. B and secure

to back of pocket using screws provided with kit.

2. Insert ISO mountable radio between ISO mount brackets and loosely attach to sides

of radio using screws provided with radio when possible or screws supplied with kit.

3. Attach ISO trim ring to face of kit.

4. Slide radio forward or backward for desired look and tighten screws.

DIN MOUNT ASSEMBLY INSTRUCTIONS

OTE: Kit must be mounted in dash prior to bending tabs on sleeve

1. Insert DIN sleeve from your new radio into the radio opening of the

installation kit as shown in Fig. A.

2. Depress the tabs from inside the sleeves opening upward, outward, and

downward to secure the installation kit to the sub-dash.

Insert left and right ISO mounting

brackets into radio opening as

shown in illustration and secure

to back of pocket using screws provided

Fig. A

Fig. B

ISO Trim Ring

(Use Optional)

Rear Bracket

Support

Rear Bracket

Support

9 2

Optional: ISO trim ring may be used

in place of after-market radio’s trim ring.

NOTES:

003-05 Lincoln Aviator

1. Carefully pry the top center Vent Panel assembly upward and remove.

2. Remove the (2) 9/32 screws securing the top of the radio trim bezel.

3. Carefully pry the lower sides of the radio trim bezel slightly forward to release and

remove the radio trim bezel.

4. Carefully pry the clock/vent assembly below the radio forward, disconnect the

harness and remove clock/vent assembly.

5. Remove the (2) 9/32 screws securing the radio to the sub-dash and save metal

bar for reinstallation.

6. Carefully pull radio forward, disconnect the wire harnesses and antenna lead and

remove radio.

(Mounting Tabs)

NOTE: Adjust mounting kit up or down for best

fit, then tighten screws

2003-05 Aviator

1. Pocket must be on top.

2. You must use the factory style rear support bracket (included).

3. Attach a backstrap from the back of the pocket to the backstrap hole on your radio.

NOTES:

(Mounting Spacers)

1. Pocket must be on top for all vehicle applications.

2. You cannot ISO mount on these applications.

3. You must use the Din mounting sleeves on these applications.

4. Remove the Mustang mounting tabs for these applications.

Spacer Nubs

* See Notes on Page 1

Remove Tabs

1. This kit only fits Cougar vehicles with a flat face Ford radio, not the curved type

(i.e. Ford Focus style).

2. Remove the Mustang mounting tabs for this application.

1. Pocket can be mounted on the top or the bottom.

2. Break off the top right locking tab of the kit. (As shown in Fig. A & B)

3. These vehicles can only be ISO mounted if the pocket is on top.

4. Remove the Mustang mounting tabs for these applications.

FIG A

FIG B

Pocket on Top

Remove Tabs

Spacer Nubs

See Notes on

Page 1

See Notes on Page 1

Remove Tabs

Pocket on Bottom

NOTE: See page 4 for 2002-05 Explorer/Mountaineer instructions.

1995-10 Ford Crown Vic

1995-97 Lincoln Continental

1995-98 Lincoln Mark VIII

1995-02 Lincoln Towncar

1995-10 Mercury Grand Marquis

2003-07 Mercury Marauder

NOTES:

001-02 Mercury/Cougar

NOTES:

1995-01 Explorer (all models)

1997-01 Mountaineer

3 8

1 For Stickshift models-Twist off the shift knob (counter clockwise)and remove.

2 Gently lift up on the trim around the gear shift lever, disconnect the harness and

slide the rubber boot off the end of the shifter knob.

3 Gently unsnap the trim bezel from around the radio, disconnect the harnesses and

remove the trim bezel.

4 Remove the (4) 9/32 screws securing the radio to the subdash.

5 Slide the Radio forward, disconnect the harnesses an antenna lead and

remove the radio

1 Gently pry outward on dash trim panel & remove.

2 Remove (2) screws securing radio to sub-dash.

3 Pull radio forward, disconnect wire harness & antenna lead & remove radio.

2001-04 Mustang

(Mounting Tabs)

**Mustang

NOTE: Position mounting holes on kit to the top

for Explorer / Mountaineer application.

NOTE: Position mounting holes on kit to the

bottom for Mustang application.

*Explorer /

Mountaineer

2002-05 Explorer /

2002-05 Mountaineer

1. This kit may be mounted in vehicle dash with pocket on top or bottom.

2. You may have to remove the factory rear support bracket, or modify the top of the

subdash to allow for the radio or pocket to fit properly.

3. Remove the Mustang mounting tabs for these applications.

1. Pocket can be on top or bottom.

2. File the top right side of the radio subdash opening so the side is straight up

and down.

3. Remove the Mustang mounting tabs for this application.

Remove Tabs

Spacer Nubs

*See Notes

on Page 1

Spacer Nubs

*See Notes

on Page 1

7 4

NOTES:

998-02 Ford Expedition

1997-02 Lincoln Navigator

2001-07 Ford Escape

2005-07 Mercury Mariner

NOTES:

DASH DISASSEMBLY:

2001-04 Ford Mustang

DASH DISASSEMBLY:

2002-05 Ford Explorer/Mercury Mountaineer

NOTES:

(Mounting Spacers)

1. Pocket must be on top.

2. Attach mounting spacers to backside of mounting tabs (if desired).

3. Attach a backstrap from the back of the pocket to the backstrap hole on your radio.

1. Set the emergency brake.

2. Remove the (2) 9/32 screws from above the instrument gauges.

3. Lower the steering column all the way down.

4. Carefully pry outward on the dash trim bezel.

5. Disconnect the wire harnesses from the headlamp switches and the climate controls

and remove the panel.

6. Remove the (2) 9/32 screws securing the factory radio to the sub-dash.

7. Pull the radio forward, disconnect the wire harnesses and antenna lead

and remove radio.

(Mounting Tabs)

NOTE: Position mounting holes on kit to the

bottom for 2003-06 Expedition application.

2003-06 Expedition

1. This kit may be mounted in vehicle dash with pocket on top or bottom.

2. For all ISO Mount applications, you must use the factory style rear support bracket.

3. Remove the Mustang mounting tabs for these applications.

Remove Tabs

Spacer Nubs

* See Notes on Page 1

DASH DISASSEMBLY:

003-06 Ford Expedition w/out Factory Navigation

NOTES:

997-08 Ford Econoline Van

(Club Wagon)

2000-05 Ford Excursion

2004 Ford F-150 Heritage

1999-03 Ford F-Series

(All)

1995-11 Ford Ranger

1999-03 Ford Windstar

1995-10 Mazda B-Series P/U

5 6

(Mounting Spacers)

1. Pocket must be on top.

2. Attach mounting spacers to backside of mounting tabs (if desired).

3. Attach a backstrap from the back of the pocket to the backstrap hole on your radio.

PAC FMK550, BKFMK550 User manual

Related papers

Other documents