INITITIAL POWER UP AND TESTING:
Once you have finished installing and securing the two thumb screws on the receiver module,
you may now plug the power supply back into AC power. Take a look at the front of the RF
receiver Module. If you properly installed the module (aligned the 16 pin connectors correctly)
the BLUE “POWER” indicting LED will now be lit.
IF THE BLUE “POWER” LED IS NOT LIT, STOP, UNLPUG THE UNIT AND RE-CHECK YOUR
MODULE INSTALATION AND ALIGNMENT!!
DATA TRANSMISSION LED
There is a LED indicator on the front panel of the receiver module that is labeled “DATA” This
LED will light up Yellow when data has been successfully transmitted form the hand-held
transmitter to the receiver module. Any time you press either the “CUT” or “ROLL” buttons on
the transmitter, the yellow “DATA” led will light up. This is an easy way to check to see if your
transmitter is properly talking to the receiver module.
WARNING:
This device is AC powered and thus can be dangerous if not used properly and safely. Do not
use this product in wet, damp or rainy environments. Keep product dry at all times. Do not
open power supply unit. It contains high voltages that could cause serious bodily harm or
fatality. No user serviceable parts inside. Please refer to a qualified service technician for any
repair. Do not modify unit in any way. Do not use the power supply for any other application
or use.
TRANSMITTER BATTERY REPLACEMENT:
The hand-held transmitter uses one standard # CR2032 coin button cell. This cell should last
for several years with intermittent use on film sets. To replace the battery, remove the battery
access cover by pressing down firmly on the label area and sliding the cover off. Once the cover
is off of the unit, remove the battery by sliding it from beneath the battery retaining holder
(metal clips). Replace the battery with the same type of battery while observing the polarity of
the battery to be sure it is installed the correct way. ***NOTE*** the battery positive (+)
symbol should be visible (facing up and out of the unit) when the battery is installed.
THERE MAY BE RISK OF EXPLOSION IF THE BATTERY IS REPLACED WITH THE WRONG TYPE!