Crain 520Z Owner's manual

Brand: Crain

Model: 520Z

Type: Owner's manual

INSTALLATION INSTRUCTIONS

FOR No. 520Z COTTON HEAD

8SJHMFZ8BZt.JMQJUBT$"t5PMM'SFFt'BY5PMM'SFF

CRAIN CUTTER CO., INC.

Rev 02/16

Center Gripper Insert

Gripper Screws (4)

Gripper Clamps (2)

Tapped Hole

Cotton Head

Washer

Bushing

Hex Nut

Flat Head

Screw

Cotton

Head

No. 520Z

$PUUPO)FBE

Figure 1

Figure 2 'JHVSF

%*4"44&.#-*/(1*/1-"5&'JHVSF

1. Remove top cover by removing 6 screws.

2. Unscrew and remove at head screw.

3. Remove hex nut, washer and bushing.

4. Remove the entire handle assembly. Hold pin

plate with left hand and using right hand pull

back on handle assembly then lift to remove.

*/45"--*/(;$0550/)&"%'JHVSF

1. Remove center gripper insert from cotton head.

2. Insert handle assembly into cotton head.

3. Tighten at head screw into tapped hole on cot-

ton head.

4. Insert bushing & washer and retighten hex nut.

5. Place top cover on top of the cotton head and

tighten with 6 screws.

6. Insert & retighten center gripper insert.

Hex Nut

Top Cover

Handle

Assembly

Washer

Bushing

Pin Plate

NOTE: To remove

handle assembly, pull

back then lift

Flat Head

Screw

Crain 520Z Owner's manual

Crain 520Z Owner's manual

Related papers

Other documents