Hose
Plastic enclosure
Fixing nut
Fixing bolt
Faucet Body
Mounting bolt
Waterlines
O-Ring
Rubber washer
Faucet extender
Rubber washer
Fixing nut
Plastic enclosure
Fixing Nut
Rubber washer
Connecting nut
Weight
Hose
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
1
2
3
4
5
6
9
8
10
11
12
13
7
14
Replacement Parts
Keep this manual for ordering replacement parts.
Trouble - Shooting
Prob l e m Caus e Acti o n
Leaks underneath handle
Aerator leaks or has an inconsistent
water flow pattern.
Water will not shut off completely.
Adjusting ring or cap has come loose.
Aerator is dirty or misfitted.
Dirty or worn out plastic washer in the
cartridge.
Tighten the adjusting ring or cap.
Unscrew the aerator to check rubber packing
or replace the aerator.
Remove handle and cartridge to check if ceramic
disk is damage permanently or dirty.
Re-install cartridge.
Contact Us Toll-Free at 1-800-775-0703; or visit our website at www.kraususa.com 2008-2011 Kraus USA Inc.
Installation
Contact Us Toll-Free at 1-800-775-0703; or visit our website at www.kraususa.com 2008-2011 Kraus USA Inc.
1
2
3
4
Weight
Fixing bolt
Connecting nut
Hose
Weight shall be fixed here
in the hose white 15.75’’
from the counter.
Screw waterlines 3 into the corresponding
holes of the faucet body 1. Fit o-ring 4 into the
bottom groove of Faucet body 1
Insert waterlines 3, fixing bolt 2, and hose 14
into the 1 3/8” drilled hole of the counter top.
Put on rubber washer 5, faucet extender 6
and rubber washer 7. Adjust faucet body 1
properly and tighten fixing nut 8 securely.
Insert plastic enclosure 9 through the hose 14, put it on to
the fixing bolt 2 and tighten with fixing nut 10. (Picture 1)
Then connect and fix the hose 14 with fixing bolt 2 using
connecting nut 12. (Picture 2) Finally, place the weight 13
on hose 14 and tighten the screw with a screw driver.