VINT NYC MNK13080ICE Installation guide

Brand: VINT NYC

Model: MNK13080ICE

Type: Installation guide

Installation of new door slab on

existing frame

The following instruction will be helpful for everyone decided to install the door slab on existing frame.

Please allow enough time for proper installation and measure the jamb, install the slab, and ensure its

proper operation.

Tools and materials recommended for installation process

• Safety glasses

• Screwdrivers

• Pencil

• Chisel or router

• Drill with bits and hole saws

• Tape measure

• Hammer

• Speedsquare or

framing square

• Your old door

Installation:

Step 1

Open a package and inspect your door on visual damages or scratches. If there are any damages

please do not install the door and contact the supplier.

Step 2

Make sure that the door properly fits the jamb. Depending on the flooring, make sure that there is

at least 1/4 of an inch clearance between door and floor. It is not recommended to cut/trim the

door.

Installation (continue):

Step 3

A) Align your old door slab with the new one as it is shown on the picture below

then using a speed square or framing square transit the exact shape of the hinge to make a cut on

the new slab. Make sure the shapes will be transited with exactly same pattern.

B) Once the shapes are transferred, you’ll need to mark the exact location of how far the hinge will

rest on the edge of the new door. Using a pencil, trace around the hinge you will use on the door

edge

C) Using a chisel and a hammer, remove wood to make the hinge flush with the door edge.

Lock bore preparation*

* you can use your old door to transfer the shapes and sizes

for bore and backset within the hinges preparation section

or, follow the guide below:

1) Measure 36” from the bottom of the door and put the mark with

pencil.

2) Using a square (speed square), measure 2-3/8” from the edge of

the door and put the mark according to 36” height mark

with a pencil for lock bore backset pilot hole.

Always check the lock’s manufacturer

instruction. Dimensions for lock bore backset can vary.

3) Using a square (speed square) put the mark in the

middle of the door’s edge for latch hole according to measurements.

(36” from the bottom and equal measurement from each side of the door)

4) Use 1-inch hole saw to bore latch hole in door edge

5) Bore the doorknob hole through the face of door using a 2 1/8-inch

hole saw; drill halfway through from each side.

6) Set latch into hole and mark its outline on the door’s edge:

7) Use hammer and chisel to cut a shallow mortise for the latch:

8) Wipe the dust with clean cloth.

After this step, follow your lockset manufacturer’s installation instruction

to finish installation of your new lockset.

VINT NYC MNK13080ICE Installation guide

Brand: VINT NYC

Model: MNK13080ICE

Type: Installation guide

Download PDF

report

VINT NYC MNK13080ICE Installation guide

VINT NYC MNK13080ICE Installation guide

Other documents