Toro Track Alignment Tool, Dingo TX Compact Utility Loaders User manual

Brand: Toro

Model: Track Alignment Tool, Dingo TX Compact Utility Loaders

Type: User manual

Form No. 3353-700 Rev A

Track Alignment Tool

For TX Compact Utility Loaders

Model No. 110-0069

Operator's Manual

W henev er y ou c hang e or remo v e a trac k, dri v e

sproc k et, or trac k guide , align the dri v e sproc k et,

trac k guide , and tension wheel using the trac k

alignment tool. Aligning the trac k assembly

will reduce w ear on the trac k and impro v e

perfor mance .

Aligning a Track

1. R emo v e the trac k; refer to the traction unit

Operator’ s Manual for instr uctions .

2. Loosen the 4 trac k guide bolts ( Figure 1 ).

Important: Do not r emo v e the bolts.

Figure 1

1. Drive sprocket spacer 3. Track alignment tool

2. Track guide bolts (only

2 shown; the other 2 are

behind the track tensioning

assembly)

3. Place the slot of the alignment tool around a

dri v e sproc k et spacer on the bottom of the

sproc k et ( Figure 1 ) and secure it with the pin

( Figure 2 ).

Figure 2

1. Pin

4. R otate the alignment tool up into the c hannel

in the trac k guide and betw een the tension

wheels ( Figure 2 and Figure 3 ), mo ving the

trac k guide as needed to allo w it to ﬁt into the

c hannel.

Figure 3

1. Track alignment tool 2. Tension wheels

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA

5. Tie with a cord or hold the trac k alignment

tool in place and tighten the trac k guide bolts ,

tor quing them to 67 to 83 ft-lb (91 to 112

N ⋅ m).

6. R emo v e the pin securing the alignment tool

and remo v e the tool.

7. Install the trac k; refer to the traction unit

Operator’ s Manual for instr uctions .

Toro Track Alignment Tool, Dingo TX Compact Utility Loaders User manual

Toro Track Alignment Tool, Dingo TX Compact Utility Loaders User manual

Toro Track Alignment Tool, Dingo TX Compact Utility Loaders User manual

Related papers

Other documents