American Standard 7353018.002 Installation guide

7353018.002
American Standard
Brand
American Standard
Model
7353018.002
Category
Wall & ceiling mounts accessories
Type
Installation guide
- 1 -
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2016
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please
read these instructions carefully before you begin.
RECOMMENDED TOOLS
1
M965721 (7/16)
INSTALLATION OF MOUNTING BRACKETS FOR ALL WALL MOUNTED ACCESSORIES
TOWNSEND
®
18" TOWEL BAR
24" TOWEL BAR
TOWEL RING
ROBE HOOK
24" DOUBLE TOWEL BAR
TOILET PAPER HOLDER
INSTALLATION
INSTRUCTIONS
7353.018 Series
7353.024 Series
7353.190 Series
7353.210 Series
7353.224 Series
7353.230 Series
Certied to comply with ANSI A112.18.1M
2
1
1
3
3
3/8" (9 mm)
3/4" (19 mm)
2
LEVEL
C
L
DRILL PILOT HOLE FOR
WOOD SCREW (2) OR
1/4" DIA. HOLE FOR
ANCHOR (3)
• The WALL MOUNTED ACCESSORIES work best if secured to a wall stud or cross brace within the wall, using the
SCREWS (2) supplied.
• If the ACCESSORY is to be installed on a tile or plaster wall, the ANCHORS (3) and SCREWS (2) should be used.
• Determine desired height and location (optional) and mark a center line. Make sure the centerline is level. Using the
MOUNTING BRACKET (1) as a template, mark the two spots for the mounting holes. If MOUNTING BRACKET (1)
is secured to a stud or cross brace. drill small pilot holes for SCREWS (2).
• For installations on tiled walls or drywall, use TILE ANCHORS (3) and SCREWS (2) for securing MOUNTING BRACKET (1) to
wall. Drill two 1/4" diameter holes a minimum of 1-1/4" deep. Insert the two TILE ANCHORS (3) ush with face of nished wall.
Place MOUNTING BRACKET (1) over TILE ANCHORS (3) and insert SCREWS (2) provided with a at blade screwdriver.
See illustration below.
• Secure MOUNTING BRACKET (1)
to wall with SCREWS (2).
Phillips Screwdriver
10'
Tape Measure
Drill
Level
Hex Key
Screwdriver
- 2 -
2
M965721 (7/16)
• Refer to Step 1 for installation of MOUNTING BRACKETS (2). Align accessory and place ACCESSORY ESCUTCHEON (1)
onto MOUNTING BRACKET (2) Secure accessory with SET SCREW (3) using a 2.5 mm HEX WRENCH (4).
TOWEL RING and ROBE HOOK INSTALLATION
2
3
4
3
4
1
1
FINISHED WALL
2
3
INSTALL TOILET PAPER HOLDER
• Refer to Step 1 for installation of MOUNTING BRACKETS (1). NOTE: The center line distance between the two
MOUNTING BRACKETS is 7-1/8" (182 mm). Make sure the two MOUNTING BRACKETS (1) are level.
• Install the ACCESSORY ESCUTCHEONS (2) on the MOUNTING BRACKETS (1). Secure ACCESSORY
ESCUTCHEONS (2) with SET SCREW (3) using a 2.5 mm HEX WRENCH (4).
2
4
LEVEL
C
L
1
3
4
3
3
4
1
FINISHED WALL
2
7-1/8" (182 mm)
- 3 -
5
6
DO: CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
24" TOWEL BAR and DOUBLE TOWEL BAR INSTALLATION
CARE INSTRUCTIONS:
18" TOWEL BAR INSTALLATION
4
M965721 (7/16)
LEVEL
1
1
2
3
4
18" (457.2 mm)
3
4
1
FINISHED WALL
2
LEVEL
1
1
2
4
24" (609.6 mm)
3
1
3
4
1
FINISHED WALL
2
• Refer to Step 1 for installation of MOUNTING BRACKETS (1). NOTE: The center line distance between the two
MOUNTING BRACKETS is 18" (457.2 mm). Make sure the two MOUNTING BRACKETS (1) are level.
• Install the ACCESSORY ESCUTCHEONS (2) on the MOUNTING BRACKETS (1). Secure ACCESSORY ESCUTCHEONS
(2) with SET SCREW (3) using a 2.5 mm HEX WRENCH (4).
• Refer to Step 1 for installation of MOUNTING BRACKETS (1). NOTE: The center line distance between the two
MOUNTING BRACKETS is 24" (609.6 mm) . Make sure the two MOUNTING BRACKETS (1) are level.
• Install the ACCESSORY ESCUTCHEONS (2) on the MOUNTING BRACKETS (1). Secure ACCESSORY ESCUTCHEONS
(2) with SET SCREW (3) using a 2.5 mm HEX WRENCH (4).
- 4 -
TOWEL RING
7353.190
TOILET PAPER HOLDER
7353.230
18" TOWEL BAR
7353.018
24" TOWEL BAR
7353.024
24" DOUBLE TOWEL BAR
7353.224
ROBE HOOK
7353.210
M964248-0070A
MOUNTING KIT
M964248-0070A
MOUNTING KIT
M965721 (7/16)
Replace the “YYY” with
appropriate finish code
POLISHED CHROME 002
SATIN NICKEL 295
POLISHED NICKEL 013
LEGACY BRONZE 278
MODEL NUMBER
7353.018 Series
7353.024 Series
7353.190 Series
7353.210 Series
7353.224 Series
7353.230 Series
TOWNSEND
®
18" TOWEL BAR
24" TOWEL BAR
TOWEL RING
ROBE HOOK
24" DOUBLE TOWEL BAR
TOILET PAPER HOLDER
HOT LINE FOR HELP
For toll-free information and answers to your questions, call:
1 (800) 442-1902
Mon. - Fri. 8:00 a.m. to 8:00 p.m. EST
Saturday 10:00 a.m. to 4:00 p.m. EST
IN CANADA 1-800-387-0369
(TORONTO 1-905-306-1093)
Weekdays 8:00 a.m. to 7:00 p.m. EST
IN MEXICO 01-800-839-1200
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

American Standard 7353018.002 Installation guide

7353018.002
American Standard
Brand
American Standard
Model
7353018.002
Category
Wall & ceiling mounts accessories
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents