Unpack the Kit
• Unpack the board. Verify package
contents according to the kit website:
freescale.com/sensortoolbox.
• Assemble the hardware by connecting
the development board to the USB
interface board. Both of these board
types have a small arrow to indicate
where to connect. See the image below.
More information can be found at
freescale.com/sensortoolbox.
Download Latest Software
• Download the latest version at
freescale.com/sensortoolbox.
• This kit uses the sensor toolbox
software. Follow the on-screen
instructions to install the communication
driver for the tool. Check back
occasionally for software updates.
Power Up
• Plug in the USB and turn the board
on using the power switch.
• Run the sensor toolbox link on
your desktop.
• Explore other sensor kits at
freescale.com/sensortoolbox.
Sensor Toolbox
Magnetometer Development Board
LFSTBEB3110 Quick Start Guide
1 2
3
Xtrinsic
Learn more at freescale.com/sensortoolbox
Freescale and the Freescale logo are trademarks of Freescale
Semiconductor, Inc., Reg. U.S. Pat. & Tm. Off. Xtrinisic is a
trademark of Freescale Semiconductor, Inc. All other product
or service names are the property of their respective owners.
© 2011 Freescale Semiconductor, Inc.
Doc Number: MAG3110QSG / REV 1
Agile Number: 926-78566 / REV B
Quick Start Guide for i.MX50
Sensor Toolbox
Magnetometer Development Board
MMA8451Q 14-bit
3-axis Accelerometer
3 x 3 x 1.0 QFN Package
Freescale MAG3110
3-axis Magnetometer
2 x 2 x 0.85 mm DFN Package
Interface Board
* Sensor
Toolbox USB
Communication
Board
On/Off Switch
*Orderable separately as LFSTBUSB.
If ordered under RD4247MAG3110, the USB
board is included.
/
