Barco service bulletin
Serial Number: 769
Date: 18/07/2008
Product: CLM series
Priority code*: D
A.
”Must” modification, Barco will provide the necessary components to perform this modification
at no charge.
B.
Improves the reliability of the product.
C.
Improves the general working conditions of t he pr odu ct.
D.
For information only.
1. “FAN LAMP SPEED LOW” ERROR D U RING
AFTER COOLING PERI OD FOR CLM SERIES
1.1 General
Phenom enon
LCD display indicated a Fan lamp x speed low error when switching off the lamps manually
(going to standby).
Cause
Lamp fan cannot restart in the after cooling period.
Normally when the lamps are switched off, an after cooling c ycle is started. The fans are
switched off f or a few seconds and starts normally again for 5 minutes.
Solution
This phenomenon is a non-issue. When restarting the projector after sufficient after cooling,
it will startup normally.
This phenomenon will be solved in a next release of the firmware.
1.2 Approvals
Modification approved by:
Quality Director
Danny Van Hoof
R&D Manager
Stijn Cuvelier
Product Director
Chris Colpaert
If you should have any more questions, or remarks, please do not hesitate to contact our
technical support team on following E-mail ad
dress “service.mne@barco.com”.
Barco nv Med ia & Entertain ment Division
Noordlaan 5, B- 8520 Kuurne
www.barco.com
Page 1 of 1
-
1
