2. Dometic
  3. Sealand Touchpad_For VF and MF Series_Electronic Flush Toilets

Dometic Sealand Touchpad_For VF and MF Series_Electronic Flush Toilets Installation guide

  • Hello! I've reviewed the installation instructions for the Dometic Touchpad designed for VacuFlush and MasterFlush electronic-flush toilets. This document provides a clear guide on how to install the touchpad including where to position it, how to create the right holes, route the wiring and making the electrical connections. I'm ready to answer your questions about installing this touchpad.
  • What should I do before starting the installation?
    What size hole should I drill for the touchpad cable?
    What type of connector is used for wiring?
    What is the clearance required behind the wall surface?
Dometic Touchpad Installation
for VacuFlush® and MasterFlush®
electronic-flush toilets
® Registered; ™ Trademark of Dometic Corporation
© Dometic Corporation
600346526 05/11
2 in.
(51 mm) 0.10 in.
(2 mm)
dia.
1.375 in.
(35 mm)
2.625 in. (67 mm)
3.25 in. (83 mm)
1 in. (25 mm)
2.5 in. (64 mm) clearance
behind wall surface required
1. Plan touchpad location so wiring cable can
reach toilet base circuit board. Be sure cable
cannot get wet.
2. Using template (below), mark center access
and fastener holes. Drill 1 in. (25 mm) center
access hole, then fasten touchpad bracket to
wall (g. 1 ).
3. Route touchpad cable through wall access
hole to oor access hole at toilet base.
4. Attach cable to back of touchpad, then snap
the touchpad onto the bracket (g. 1 ).
5. WITH ELECTRICAL POWER OFF, connect
wiring cable from the touchpad to the RJ45
connector on the circuit board of the toilet
base (g. 2 ).
2
1
Caution!
If replacing a different style electronic
ush switch, WITH ELECTRICAL POWER
OFF, be sure to disconnect wiring from old
switch before installing new touchpad.
/