2. Rugged Ridge
  3. 11703.10

Rugged Ridge 11703.10 Installation guide

  • Hello! I've reviewed the installation instructions for the Omix-Ada Crossbar Adapter 11703.10. This document outlines how to mount the adapters designed for Thule® and Yakima® accessories to 2" or 50mm tubing, using M6 hardware. I'm here to help if you have any questions about the installation process or the adapter's features.
  • What accessories are these crossbar adapters designed to work with?
    What size tubing do these crossbar adapters mount to?
    What size hardware is used to assemble these crossbar adapters?
Copyright © 2013 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 1/2
11703.10
Crossbar Adapters
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Contents:
1. Upper Clamp Bracket (4)
2. Lower Clamp Bracket (4)
3. Crossbar Bracket (4)
4. M6x20 Flange Bolts (16)
5. M6 Nylon Lock Nuts (24)
6. M6 Flat Washer (24)
Read all instructions thoroughly before installation.
Crossbar adapters are designed to work Thule® and Yakima® accessories and
mount to Rugged Ridge® 11703.01, 11703.02 or other 2” or 50mm tubing.
NOTICE
1
2
3
4
5
6
Copyright © 2013 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
1. Use the supplied M6 hardware to
attach the upper and lower clamp brack-
ets to the tube.
Note: It is recommended to leave fasten-
ers loose until desired position is chosen
based on aftermarket accessories to be
installed.
2. Using the supplied M6 hardware,
attach the crossbar bracket over the
chosen aftermarket crossbar. Tighten until
crossbars are secure.
Note: It is recommended to leave fasten-
ers loose until desired position is chosen
based on aftermarket accessories to be
installed.
Crossbar Adapters
11703.10
Page 2/2
/