ILuminar IL-HMOL-720 User manual

IL-HMOL-720
Brand
ILuminar
Model
IL-HMOL-720
Type
User manual

The ILuminar IL-HMOL-720 is a high-performance LED grow light with an impressive 1944 µmol/s PPF and an efficacy of 2.7 µmol/J. With a wide 120º light distribution, this fixture is perfect for illuminating large grow areas. Dimmable and 0-10V controllable, the IL-HMOL-720 allows for precise light intensity adjustment to suit the needs of your plants. Its passive/extruded case design provides efficient cooling to ensure optimal performance and longevity.

The ILuminar IL-HMOL-720 is a high-performance LED grow light with an impressive 1944 µmol/s PPF and an efficacy of 2.7 µmol/J. With a wide 120º light distribution, this fixture is perfect for illuminating large grow areas. Dimmable and 0-10V controllable, the IL-HMOL-720 allows for precise light intensity adjustment to suit the needs of your plants. Its passive/extruded case design provides efficient cooling to ensure optimal performance and longevity.

USER MANUAL
HYPERMOL Full Spectrum
1-877-540-5588
iluminarlighting.com
[email protected]
IL-HMOL-720
720W
3
2
1-877-540-5588
iluminarlighting.com
[email protected]
© Copyright 2023, ILUMINAR Lighting
Subject to change without notice.
2
CONTENTS
Please read this manual thoroughly prior to installing or
operating the ILUMINAR HYPERMOL
• Observe all safety precautions (see page 10), seek the services of a
qualified electrician, installation professional, or call ILUMINAR Lighting
technicians for assistance.
• DO NOT handle or touch the fixture while in use.
• Connect the fixture only to the power sources of the appropriate voltage
using the correct AC plug type. Protect power cables from being pinched,
walked on, or otherwise damaged. Be especially careful where the power
cable enters the power outlet to the unit. Only connect the fixture to an
electrical outlet or extension cord of comparable standard and level
rating. Connect the fixture ONLY to the power sources of the correct
voltage using the plug received.
• The fixture should only be cleaned as directed. Always seek service for
your system by qualified service personnel if any of the following occur:
1. The fixture shows a noticeable change in performance.
2. The powersupply cord or plug is damaged.
3. The fixture has been dropped, or the exterior is damaged.
Pre-Install Information ........................................
Technical & Physical Specifications ......................
Hardware & Accessories ....................................
Hanging Installation ..........................................
Cable Logic Instructions .....................................
Important Cautions & Warranty ..........................
2
3
4
6-7
8-9
10
© Copyright 2023, ILUMINAR Lighting
Subject to change without notice.
TECHNICAL SPECS
720W LED SPECTRUM
MOUNTING & COVERAGE
LED Lighting Solution
VOLTAGE:
SKU:
WATTS: 720W
100-277V
IL-HMOL-720
Rated Voltage 120-277V AC
PPF 1944 µmol/s
Efficacy 2.7 µmol/J
120º
Min Power Factor >90%
THD
Minimum Mounting Height
LED Lifespan (90% of Life)
< 20%
BTU
6” to top of Canopy
50,000+ hours
2,462
Dimmable
Ambient Temperature
0-10V Controllable
Emitter Cooling
0 - 35°C / 32 - 95°F
Light Distribution
Passive / Extruded Case
PHYSICAL SPECIFICATIONS
Length 1065 mm 41.9”
43.5”
2.3”
50.3lbs
Width 1005 mm
Height 58 mm
Weight 22.8kg
VOLTAGE AND AMPERAGE
6.00A
208V
120V
3.46A
220V
240V
3.27A
3.00A
277V 2.60A
1065mm / 41.9”
1105mm / 43.5”
58mm / 2.3”
1-877-540-5588
iluminarlighting.com
[email protected]
HARDWARE AND ACCESSORIES
The HYPERMOL can be hung from
rope ratchets or can be mounted
to a rack.
Before you begin installation,
check that you have all the
necessary parts to begin.
1 HYPERMOL Fixture
1 Cable
IN THE BOX
4 Rope Ratchets
4© Copyright 2023, ILUMINAR Lighting
Subject to change without notice.
7
6
1-877-540-5588
iluminarlighting.com
[email protected]
© Copyright 2023, ILUMINAR Lighting
Subject to change without notice.
HANGING INSTALLATION
Lift the LED and attach the carabiners
to pre-installed hooks from ceiling or
mounting beam. The Ratchets should
be installed closest to the LED (and not
the ceiling).
A: Remove slack to raise fixture.
B: Give slack to lower fixture.
To suspend mount, attach the 4 rope ratchets that come packaged with
this fixture to the LED.
1
2
Once fixture is hanging with all LED bars installed, connect the power cable
(blue tip) from the outlet to one side of the fixture.
3
Power Supply
AC INPUTController Cable
A
B
! CAUTION when handling your ILUMINAR Fixture. The
LED array should NOT come in contact with sharp objects.
DO NOT touch diodes or apply direct force to the diodes
as this can/will cause permanent damage.
8© Copyright 2023, ILUMINAR Lighting
Subject to change without notice.
CABLE LOGIC CONNECTIONS
1-877-540-5588
iluminarlighting.com
[email protected]
With our ILUMINAR Lighting Professional Systems, our new LED lighting fixtures allow
growers to connect multiple fixtures using a single power cable.
This cabling solution forms a fixture-to-fixture connection to the power source. Our grow
light cables and grow light accessories eliminate the need for the typical mess of LED
lighting cables, which have various fixtures with multiple cables running to several power
sockets.
Please consult with our lighting layout designers to ensure proper spacing of outlets for
your unique setup.
3
3
Cable Logic Secondary AC
Extension Cables
2Cable Logic Single Joint
4Cable Logic 110V-480V
Panel Mount
Plug Options:
Cable Logic 120V AC Power
Cable Logic 240V AC Power
Cable Logic 277V AC Power Main or Sub Panel
Electrician Wire to Panel
Junction Box
1.5 m / 5 ft
Cable Logic Main-Line AC
Extension Cable
1
Available Options
0.9 m / 3 ft
1.8 m / 6 ft
4.5 m / 15 ft
Available Options
0.9 m / 3 ft
1.8 m / 6 ft
0.15 m / 0.5 ft
0.25m / 0.85 ft
RJ9 to RJ14 (Included with Touch+ Controller) Touch+ Controller
Cable Logic
Dimming Cable
Available Options
0.3 m / 1.3 ft
1.8 m / 6 ft
3 m / 10 ft
6 m / 20 ft
3m / 10 ft
Hash Controller
10 © Copyright 2023, ILUMINAR Lighting
Subject to change without notice.
CAUTION
1. Leave at least one inch of space between the fixture and the mounting area
for maximum performance and lifespan.
2. ALWAYS wear protective eye wear when looking directly at the diodes to
prevent eye damage.
3. Only handle, clean or move fixture when it’s unplugged and completely
cool.
4. Keep the fixture free of dust, debris, deposits to ensure the maximum
potential of the fixture.
5. NEVER use cloth to clean the diodes. This will scratch the diodes and could
potentially break or dislodge them.
6. DO NOT use chemicals to clean the fixture. Use ONLY low pressure air or
low pressure water to remove dust and debris.
7. Do NOT exceed 70% max load for breakers due to Inrush current in LED
fixtures.
8. Do NOT use sulfur vaporizers.
Please read the following list carefully prior to beginning installation.
At ILUMINAR, we stand behind our products and our technology
as well as our customers. All ILUMINAR LED fixtures are backed
by our 5-Year Guarantee. Please visit our website iluminarlighting.
com/warranty for more information.
GUARANTEE
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

ILuminar IL-HMOL-720 User manual

IL-HMOL-720
Brand
ILuminar
Model
IL-HMOL-720
Type
User manual

The ILuminar IL-HMOL-720 is a high-performance LED grow light with an impressive 1944 µmol/s PPF and an efficacy of 2.7 µmol/J. With a wide 120º light distribution, this fixture is perfect for illuminating large grow areas. Dimmable and 0-10V controllable, the IL-HMOL-720 allows for precise light intensity adjustment to suit the needs of your plants. Its passive/extruded case design provides efficient cooling to ensure optimal performance and longevity.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents