2. BLOTZ
  3. B10-ST-001

BLOTZ B10-ST-001, B10_ST_001 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Cargo Container B10-ST-001. This document provides a clear, step-by-step guide for assembling the 10mm model, from gluing the sides to attaching the roof plates. I'm ready to assist with any questions you may have about the assembly process or the model itself.
  • What type of glue is needed?
    What tool is needed to remove sections?
    How to hold parts together while glue dries?
10mm Cargo Containers #1
B10-ST-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Each cargo container is formed from the pieces shown
above.
Glue the top and bottom to the sides.
The attack the two end pieces.
Finally add the two roof plates.
The completed containers.
/