2. MooreCo
  3. Wall Mount Display Case

MooreCo Wall Mount Display Case Assembly Instructions

  • Hello! I've reviewed the instructions for the Best-Rite Wall Mount Display Case #90 HC and #90 W. This document outlines the steps for assembling and mounting the display case, including using the L-brackets and appropriate screws for different wall types. I'm here to answer any questions you have about the assembly process or the components.
  • What type of screws are used to attach the L bracket to the bottom of the display case?
    What type of screws are used to mount the unit to the wall?
    What should I do if I have missing or damaged parts?
1
Parts List
3. Find the desired location for the unit and mark the Stud
locations on a Sheetrock/ Wood/Metal Stud wall. You
MUST hit the studs with the 1 1/4” Screws (B) on this
type wall.
2.Attach the “L” Angle Bracket (P-2) to the bottom
of the Display Case (P-1) using 1/2” Screws (A).
6.Position the Display Case (P-1) on the wall over your
drilled holes(masonary wall) and attach with1 1/4” Screws
(B).
Hardware List
P-1 Display Case 1 EA
P-2 “L” Angle Bracket 1 EA
Remove all the glass shelves and shelf supports
from inside the unit.
Missing Parts or UPS Damaged Parts
For Your Convenience you can
EMAIL us at
[email protected]
24HOURS 7 DAYS A WEEK
R
EAD
T
HROUGH
I
NSTRUCTIONS
FROM
BEGINNING
TO
END
BEFORE
STARTING
TO
ASSEMBLE
UNIT
.
Wall Mount Display Case
# 90 HC and # 90 W
P-2
A
P-1
A 1/2” Screw 4 EA
B 1 1/4” Screw 8 EA
C Plastic Wall Anchor 8 EA
4Use a 1/4” drill bit to drill through the top and bottom
“L” Angle Brackets (P-2). [Keep drilling through
and into masonry walls at least 1”]
5. Insert Plastic Wall Acnhors (C) into holes in masonry
walls only.
B
B(Hidden)
C
1/4” Predrilled Hole
90HC&W_2-4-10
/