Shimano SM-SH85 Service Instructions

Brand: Shimano

Model: SM-SH85

Type: Service Instructions

General Safety Information

WARNING

– To avoid serious injuries:

●

This cleat adapter is especially made for attaching Shimano

road racing shoes to Shimano road pedals (SPD-R).

Any other combination should not be used.

●

Cleats that can be used with this cleat adapter are SM-SH90,

SM-SH91 and SM-SH92.

●

Before attaching this cleat adapter to the shoe, refer to the

Service Instructions of both the shoes and the pedals.

●

Obtain and read the service instructions carefully prior

to installing the parts. Loose, worn, or damaged parts may

cause serious injury to the rider.

We strongly recommend only using genuine Shimano

replacement parts.

●

If you have any questions concerning your pedals, contact a

professional dealer.

Be sure to read and follow the above warnings carefully,

otherwise your shoes may not release from the pedals, or

they may release unexpectedly and slip from the pedals,

causing a fall that could result in severe injury.

SI-SH85A-002

SM-SH85

Cleat adapter

Technical Service Instructions

Attaching the cleat adapter

Attach the cleat adapter onto the bottom of the shoe and tighten it

securely.

Tightening torque:

3 – 4 N•m {26 – 35 in. lbs.}

Cleat adapter fixing bolt

Cleat adapter

3 mm Allen key

Cleat nut

Attaching the cleats

Attach the cleat provisionally onto the cleat adapter in the order

shown in the figure.

Provisional tightening torque

for cleat fixing bolts:

2.5 N•m {22 in. lbs.}

-SH90

PAN

Cleat fixing bolt (for front)

Cleat washer (for front)

Cleat

(SM-SH90/SM-SH91/SM-SH92)

Cleat adapter

4 mm Allen key

Cleat fixing bolt (for rear)

Cleat washer (for rear)

Cleat holder

Pontoon

(cleat rubber)

The cleat has an adjustment range of 15 mm front to back and

5 mm right to left. After provisionally tightening the cleat, adjust it

until the optimum cleat position is obtained. Adjustment can also

be carried out with the shoes already attached to the pedals.

If you cannot find the optimum position

for yourself, please contact the place

of purchase.

After you have determined the best cleat position, firmly tighten

the cleat fixing bolts with a 4 mm Allen key.

Tightening torque:

5 – 6 N•m {44 – 52 in. lbs.}

SM-SH90

JAPAN

SI-SH85A-002-00

3-77 Oimatsu-cho, Sakai-ku, Sakai-shi, Osaka 590-8577, Japan

Industrieweg 24, 8071 CT Nunspeet, The Netherlands Phone: +31-341-272222

One Holland, Irvine, California 92618, U.S.A. Phone: +1-949-951-5003

SHIMANO AMERICAN CORPORATION

SHIMANO EUROPE B.V.

SHIMANO INC.

* Service Instructions in further languages are available at :

http://techdocs.shimano.com

Please note: Specifications are subject to change for improvement without

notice. (English)

Shimano SM-SH85 Service Instructions

Shimano SM-SH85 Service Instructions

Shimano SM-SH85 Service Instructions

Related papers