2. WHALEN SPEED
  3. WSRD 2017+ CAN AM X3 Injector
WSRD 2017+ CAN AM X3 Injector

WHALEN SPEED WSRD 2017+ CAN AM X3 Injector Installation guide

  • Hello! I've reviewed the user manual for the 2017+ CAN AM X3 injector installation. This document provides detailed steps on how to replace your vehicle's injectors, including safety measures related to the pressurized fuel rail. I'm ready to assist you with any questions you have about the installation process or the components described in the manual.
  • Do I need to remove the fuel line for injector installation?
    What type of screws should be removed from the intake manifold?
    What is necessary to remove from each injector?
    What should be done after installing injectors?
WSRD 2017+ CAN AM X3 INJECTOR INSTALLATION
P:269-415-0040
EMAIL: [email protected]
•PLEASE BE SURE TO HAVE PROPER SAFTY EQUIPMENT AS THE
FUEL RAIL
MAY BE PRESSERIZED.
AND BY REMOVING AN INJECTOR, IT WILL RELEASE
THAT FUEL. PLEASE BE AWARE.
WHALEN'S SPEED RESEARCH AND DEVELOPMENT
1
•you
do not
have to
remove fuel
line
WHALEN'S SPEED RESEARCH AND DEVELOPMENT
2
•unplug the injector connector from the factory
injectors.
•remove both
t30 Torx
mounting screws from intake
manifold.
WHALEN'S SPEED RESEARCH AND DEVELOPMENT
3
•start removing fuel rail
•
KEEP injectorS installed
WHALEN'S SPEED RESEARCH AND DEVELOPMENT
4
•we removed the entire rail (shown in picture) from the
engine bay, just to give us room to swap the injectors out.
•EACH INJECTOR HAVE A SAFTETY CLIP. THEY'LL NEED TO BE REMOVED.
WHALEN'S SPEED RESEARCH AND DEVELOPMENT
5
•with THE safety clips
removed from each
injector. remove them.
•beware of fuel
•clean and replace with
Wsrd big injectors.
oO-RING GREASE ISN'T A BAD
IDEA FOR EASIER NSTALL.
WHALEN'S SPEED RESEARCH AND DEVELOPMENT
6
WHALEN'S SPEED RESEARCH AND DEVELOPMENT
7
•Reinstall fuel rail with new injectors back into the intake manifold. next will be
installing mounting bolts back and tightening them down to secure fuel rail.
•
install supplied injector harness adapters
to new injectors and into oem engine harness
•after everything is properly installed, key-on power and
confirm theres no fuel leaks
/